小窓モード


プレミアム

ログイン
設定

設定

Weblio 辞書 > 英和辞典・和英辞典 > 英和専門語辞典 > 合一温度の英語・英訳 

合一温度の英語

ピン留め

追加できません

(登録数上限)

単語を追加

英訳・英語 sintering temperature


クロスランゲージ 37分野専門語辞書での「合一温度」の英訳

合一温度


「合一温度」の部分一致の例文検索結果

該当件数 : 18



例文

(2) 粘性率は温度に依存し、液体の場合、一般には温度が高いほど粘性率は小さくなる。例文帳に追加

2) Viscosity depends on temperature, and in the case of a liquid, viscosity generally becomes lower as the temperature increases. - 経済産業省

一般給湯の設定温度より浴槽給湯の設定温度が高い場合、一般給湯時に一般給湯設定温度から逸脱した高い温度の湯が出湯されることがない給湯機を提供する。例文帳に追加

To provide a water heater which can prevent supply of hot water set high exceeding a general hot water supply set temperature during general hot water supply when the set temperature of bath hot water is higher than the set temperature of the general hot water supply. - 特許庁

季節モード入切スイッチ11をOFFにした場合、一年を通して、出湯温度設定器12で設定された温度の湯が出湯口7から流出する。例文帳に追加

When a season mode on/off switch 11 is off, hot water at temperature set in an effluent hot water temperature setting unit 1 is flowed out from the effluent hot water port 7 through the year. - 特許庁

電子レンジのヒータ加熱調理において、加熱室の設定温度がT_2とされている場合、一旦、加熱室は、T_2 より10℃程度低い温度であるT_1 で保持された後、T_2 となるように加熱される。例文帳に追加

When the temperature in the heating chamber of a microwave oven is set at T2 at the time using the oven for cooking by energizing the heater of the oven, the heating chamber is once maintained at a temperature T1 which is lower than the set temperature T2 by about 10°C, and then, heated to the temperature T2. - 特許庁

非結晶性ポリエステル、結晶性ポリエステル、着色剤の凝集及び合一を含むトナー製造方法であって、前記合一は前記結晶性ポリエステルの溶融開始点温度より低い温度で行われることを特徴とする方法。例文帳に追加

The manufacturing method of toner comprises the aggregation and coalescence of amorphous polyester, a crystalline polyester and a colorant, wherein the coalescence is performed at a temperature lower than the onset melting temperature of the crystalline polyester. - 特許庁

トナーは、ラテックス、着色剤の水性分散物、および任意適用のワックス分散物を接触させてブレンドを形成する工程と、ブレンドをラテックスのガラス転移温度より低い温度で加熱して凝集したトナー粒子を形成する工程と、反応性の合一助剤を添加し、トナー粒子を合一させる工程と、合一したトナー粒子を回収する工程と、を含む方法により調製される。例文帳に追加

The toner is prepared by the method including steps of contacting a latex, an aqueous colorant dispersion, and an optional wax dispersion to form a blend, heating the blend at a temperature below the glass transition temperature of the latex to form aggregated toner particles, adding a reactive coalescing agent to coalesce the toner particles, and recovering the coalesced toner particles. - 特許庁

例文

複数の室内機のうち一台が暖房運転を行っている時、停止室内機の配管温度センサー(中央)の温度が一定温度以上を連続する場合、一定時間後に最大周波数を制御し、一台が暖房運転を行っている時の停止室内機の過負荷防止制御手段としたものである。例文帳に追加

If the temperature of a piping temperature sensor (at a center) in the stopping indoor unit continues a prescribed temperature or higher, when one of a plurality of indoor units is operated for heating, there is provided an overload preventing control means of the stopping unit by controlling a maximum frequency after a prescribed time, when one is operated for heating. - 特許庁

>>例文の一覧を見る


調べた例文を記録して、 効率よく覚えましょう
Weblio会員登録無料で登録できます!
  • 履歴機能
    履歴機能
    過去に調べた
    単語を確認!
  • 語彙力診断
    語彙力診断
    診断回数が
    増える!
  • マイ単語帳
    マイ単語帳
    便利な
    学習機能付き!
  • マイ例文帳
    マイ例文帳
    文章で
    単語を理解!
  • その他にも便利な機能が満載!
Weblio会員登録(無料)はこちらから

「合一温度」の部分一致の例文検索結果

該当件数 : 18



例文

そして、冷却前減圧工程s4では、配管内を流過する加熱加圧状態にある合一樹脂粒子スラリーを、冷却工程s5において所定の温度まで冷却する前に減圧する。例文帳に追加

In the pressure reduction step s4 before cooling, the coalesced resin particle slurry flowing through the pipe in a heated and pressurized state is subjected to pressure reduction before cooled down to a predetermined temperature in a cooling step s5. - 特許庁

したがって、前記被覆シート1に熱が与えられた場合、一定時間経過後に、前記シート基材2の表面と前記熱伝導部材3の表面との間に温度差が生じ、肌に適度な高温感を与えることができる。例文帳に追加

When heat is applied to the cover sheet 1, a temperature difference is generated between the surface of the sheet base material 2 and the surface of the heat conducting member 3 after a specified time passes thereby allowing the skin to feel a moderate high temperature. - 特許庁

そして、前記複合一体化物を熱風炉46に供給し、TPOの融点近傍の温度で外部加熱してスポンジゴムの加硫を完了させる。例文帳に追加

Then, the composite integral substance is fed to an air-heating furnace 46, and the vulcanization of the sponge rubber is completed by the external heating at the temperature at about the melting point of the TPO. - 特許庁

更には、複数回に分けて定着プロセスを実行する場合、一回で定着を終了する場合と異なる適正温度に制御する制御手段を設ける。例文帳に追加

Furthermore, for the case of performing the fixing process in a plurality of stages, a control means in provided for controlling the fixing temperature to proper temperatures different from the case where fixing is terminated at a time. - 特許庁

これにより、車軸センサの周りの温度が徐々に変化して、両チューブ16,16の内部圧力に差圧が生じた場合、一方から他方のチューブ16へと連絡管路17を介して空気が流れて差圧が解消される。例文帳に追加

The differential pressure is solved by the flow of the air from one tube to the other tube 16 via the communication conduit 17 when a temperature around an axle sensor is gradually changed and the difference in internal pressure is found between both tubes 16, 16. - 特許庁

また、電子写真用トナーの製造方法は、結着樹脂粒子と着色剤粒子との合一工程または会合工程の後、少なくとも1℃/分以上の速度で結着樹脂の結晶化温度以下まで降温してトナー粒子を生成する。例文帳に追加

In the producing method of the toner for electrophotography, the composition stage or the association stage of binding resin particles and colorant particles is performed, and then the temperature of the particles is lowered to be equal to or under the crystallization temperature of the binding resin at least at speed equal to or above 1°C/minute, thereby, toner particles are produced. - 特許庁

圧縮機の停止時に、その停止直前の運転モードが暖房サイクル除湿運転である場合、一例として外気温度TaがTa<10℃であれば最も長い6分マスクとし、10℃≦Ta<15℃であれば5分マスクとし、Ta≧15℃であれば4分マスクとする。例文帳に追加

When the operation mode just before stopping is a heating cycle dehumidifying operation in stopping the compressor, for example, longest six-minute mask is set when outside temperature Ta is lower than 10°C, five-minute mask is set for 10°CTa15°C, and four-minute mask is set for 15°C ≤ Ta. - 特許庁

例文

単結晶フェライトと多結晶フェライトとが接合一体化されてなる接合フェライトを用いて磁気コアが構成される磁気ヘッドの製造方法において、前記接合フェライトを前記磁気コアに適合する形状に成形加工した後、その接合フェライト単体に対して最高温度帯域が850〜950℃となる熱処理を施す。例文帳に追加

In the manufacturing method for a magnetic head wherein the magnetic core is constituted by using the joined ferrite which is formed by integrally joining the single crystalline ferrite and the polycrystalline ferrite to each other, after the joined ferrite is formed in the shape fitted to the magnetic core, the joined ferrite single body is subjected to the thermal treatment of 850-950°C maximum temperature zone. - 特許庁

>>例文の一覧を見る

「合一温度」の英訳に関連した単語・英語表現

合一温度のページの著作権
英和・和英辞典 情報提供元は 参加元一覧 にて確認できます。

   
株式会社クロスランゲージ株式会社クロスランゲージ
Copyright © 2024 Cross Language Inc. All Right Reserved.

ピン留めアイコンをクリックすると単語とその意味を画面の右側に残しておくことができます。

こんにちは ゲスト さん

ログイン

Weblio会員(無料)になると

会員登録のメリット検索履歴を保存できる!

会員登録のメリット語彙力診断の実施回数増加!

無料会員に登録する

このモジュールを今後表示しない
みんなの検索ランキング
閲覧履歴
無料会員登録をすると、
単語の閲覧履歴を
確認できます。
無料会員に登録する
英→日 日→英
こんにちは ゲスト さん

ログイン

Weblio会員(無料)になると

会員登録のメリット検索履歴を保存できる!

会員登録のメリット語彙力診断の実施回数増加!

無料会員に登録する

©2024 GRAS Group, Inc.RSS