突付継の英語

溝３２は、継手本体１０にナット１２を取り付けたとき突出部６０を収容して取囲む。例文帳に追加

The groove 32 stores the projected part 60, when attaching the nut 12 to the joint body 10, to surround it. - 特許庁

二つの軒樋１の突き合わせた端部の両側に亘って取り付ける内継手５である。例文帳に追加

The internal joint 5 is mounted extensively over both sides of the abutted end sections of the two eaves gutters 1. - 特許庁

第１の部材１０の継手部１２は段付状に折り曲げられ、その上部に突部１４を有する。例文帳に追加

The joint part 12 of the first member 10 is bent as stepping state and in this upper part, a projecting part 14 is provided. - 特許庁

第１の部材１０の継手部１２は段付状に折り曲げられ、その上部に突部１４を有する。例文帳に追加

The joint part 12 of the first member 10 is bent as stepping state and in the upper part, a projecting part 14 is provided. - 特許庁

車両に設けた衝突用加速度センサからの検出信号に応じて衝突を判定する衝突判定装置において、衝突用加速度センサの取付角度がずれた際にも正常な衝突判定を継続可能とする。例文帳に追加

To continuously and normally execute a collision determination even when the mounting angle of an acceleration sensor for collision is deviated in a collision determination device determining a collision based on a detection signal from the acceleration sensor for collision provided on a vehicle. - 特許庁

２本の糸端１ａ、１ｂ同士を突き合わせ、その突き合わせ部分に接着剤３を付与し、接着剤３を硬化処理して糸条を継ぐようにした。例文帳に追加

Two thread ends 1a and 1b are brought together and the adhesive 3 is applied to the ends brought together and is cured to ending the threads together. - 特許庁

底塊部管取付壁３は、管継手部２３を有しており、管継手部２３は、底塊部管取付壁３の外面に突設され、外周面３５に突起４５を有している。例文帳に追加

A bottom mass pipe mounting wall 3 has a pipe coupling 23, which is provided to protrude from the outer surface of the mounting wall 3 and has a projection 45 on its outer peripheral surface 35. - 特許庁

傾斜面25におけるヘッダ３寄りの側縁部を除いた部分が斜め上方に突出し、当該突出部27の突出端面が、斜め上方を向き、かつ配管接続用継手部材を取り付ける取付面28となっている。例文帳に追加

A part excluding a side edge portion near the header 3, of the inclined face 25 is projected obliquely upward, and a projecting end face of the projecting portion 27 is directed obliquely upward, and applied as the mounting face 28 for mounting the joint member for piping connection. - 特許庁