小窓モード


プレミアム

ログイン
設定

設定

Weblio 辞書 > 英和辞典・和英辞典 > 専門用語対訳辞書 > RESISTOR 1 CIRCUIT INの意味・解説 

RESISTOR 1 CIRCUIT INとは 意味・読み方・使い方

ピン留め

追加できません

(登録数上限)

単語を追加

Weblio専門用語対訳辞書での「RESISTOR 1 CIRCUIT IN」の意味

RESISTOR 1 CIRCUIT IN

Weblio専門用語対訳辞書はプログラムで機械的に意味や英語表現を生成しているため、不適切な項目が含まれていることもあります。ご了承くださいませ。

「RESISTOR 1 CIRCUIT IN」の部分一致の例文検索結果

該当件数 : 182



例文

A circuit board 5, provided with a resistor circuit pattern whose surface includes a variable resistor, is housed in an insulating case 1 whose one edge is open.例文帳に追加

表面に可変抵抗体を含む抵抗体回路パターンを備えた回路基板5を一端開口状の絶縁ケース1の内部に収納する。 - 特許庁

Each pixel circuit is connected to the adjacent pixel circuits via a resistor Rn in a connection mode 1 of the photodetector PD1 and the resistor Ri.例文帳に追加

各画素回路は、フォトディテクタPD1と抵抗Riとの接続ノード1において抵抗Rnを介して隣接する画素回路と接続される。 - 特許庁

A resistor 21 is connected in series to a reactor 3 that is connected to each of the phases (a) to (c) of a transmission cable 1, while at the same time a switch 22 is connected in parallel with the resistor 21 to compose a resistor circuit 23.例文帳に追加

a相〜c相の送電ケーブル1に接続された各相のリアクトル3には、抵抗器21が直列に接続されると共に、抵抗器21と並列に開閉器22が接続されており、抵抗回路23を構成している。 - 特許庁

The tuner circuit is configured to compensate a series resistance component R_0+1 by connecting the negative resistor circuit N in series with a series resonance circuit M.例文帳に追加

直列共振回路Mに直列に負性抵抗回路Nを接続して直列抵抗成分R_0+1を補償するよう構成する。 - 特許庁

A current limiter 1 is constituted of a main circuit 2, in which a resistor R1 the electric resistance value which has a positive temperature coefficient is arranged and an auxiliary circuit 3 in which a resistor R2, the electric resistance value of which has a negative temperature coefficient is arranged in parallel with the resistor R1, and the auxiliary circuit 3 is grounded via a switch Sw.例文帳に追加

電流制限器1を、電気抵抗値が正の温度係数を有する抵抗体R1を配した主回路2と、これに並列に電気抵抗値が負の温度係数を有する抵抗体R2を配した副回路3で構成し、副回路3は、スイッチSwを介して接地される。 - 特許庁

In the optical head device 1, a resistor circuit 10 for adjusting the laser output includes a variable resistor 11 for adjusting the output of a laser light source and a fixed resistor 12 of 0 Ω connected in series with the variable resistor 11.例文帳に追加

光ヘッド装置1において、レーザ出力の調整を行うための抵抗回路10は、レーザ光源の出力調整をするための可変抵抗器11と、可変抵抗器11に直列に接続された0Ωの固定抵抗12とを備えている。 - 特許庁

例文

A gate electrode of the GaAs FET11 is connected with the end of a resistor 12 for distortion improvement in the high frequency region of the switch circuit 1, and a resistor 13 for distortion improvement in the low frequency region of the switch circuit 1 is prepared between the signal line L1 and the resistor 12.例文帳に追加

GaAs FET11のゲート電極には、スイッチ回路1の高周波領域での歪み改善のための抵抗12の一端が接続されており、信号ラインL1と抵抗12の他端との間には、スイッチ回路1の低周波領域での歪み改善のための抵抗13が設けられている。 - 特許庁

>>例文の一覧を見る


調べた例文を記録して、 効率よく覚えましょう
Weblio会員登録無料で登録できます!
  • 履歴機能
    履歴機能
    過去に調べた
    単語を確認!
  • 語彙力診断
    語彙力診断
    診断回数が
    増える!
  • マイ単語帳
    マイ単語帳
    便利な
    学習機能付き!
  • マイ例文帳
    マイ例文帳
    文章で
    単語を理解!
  • その他にも便利な機能が満載!
Weblio会員登録(無料)はこちらから

「RESISTOR 1 CIRCUIT IN」の部分一致の例文検索結果

該当件数 : 182



例文

Circular variable resistor patterns VR1 to VR3 are formed on the surface of a circuit board 1, and throughholes H1 to H3 are bored in the center of the circular variable resistor patterns VR1 to VR3 penetrating through the circuit board 1.例文帳に追加

回路基板1表面に印刷形成されている円弧状の可変抵抗パターンVR1〜VR3の中心に、回路基板1を貫通する貫通孔H1〜H3を開ける。 - 特許庁

The printed circuit substrate 10 has a resistor 1 mounted as a dummy component which does not affect an influence to the circuit operation of the circuit component by soldering the circuit component, in such a manner that stress applied to the soldered part of the resistor 1 is set to more stringent conditions than the stress which is applied to the soldered part of the circuit component.例文帳に追加

回路部品をはんだ付け実装したプリント基板10上に、前記回路部品の回路動作に影響しないダミー部品としての抵抗器1をはんだ付け実装し、この抵抗器1のはんだ付け部に加わる応力を前記回路部品のはんだ付け部に加わる応力よりも厳しい条件とする。 - 特許庁

In the device 1, the snubber voltage detection circuit 40 detects both-end voltages of a resistor element R5 of the snubber circuit 30.例文帳に追加

この装置1では、スナバ電圧検出回路40がスナバ回路30の抵抗素子R5の両端電圧を検出する。 - 特許庁

More specifically, the input terminal 1, the input-voltage discrimination circuit 3, the input backflow prevention circuit 2, and the pull-up resistor R1 are arranged in this order.例文帳に追加

即ち、入力端子1、入力電圧識別回路3、入力逆流防止回路2、プルアップ抵抗R1の順に配列されている。 - 特許庁

A selection circuit 2 is connected to generating points of voltages V1, V2 in a series resistor 1 according to a control output of a control circuit 3.例文帳に追加

選択回路2は制御回路3の制御出力に従い直列抵抗1のうち電圧V1、V2の発生点と接続される。 - 特許庁

A microcomputer 21 is provided with a pull-up circuit 22 for connecting an input terminal PI that is connected to a sensor circuit 1 in a pull-up state through a resistor RPU.例文帳に追加

マイコン21は、センサ回路1に接続する入力端子PIを抵抗RPUを介してプルアップ状態に結線するプルアップ回路22を備える。 - 特許庁

In the electric leakage detection circuit, the control circuit 5 switches the switching elements 8 of the circuit block 3 in turn, the resistance voltage detection circuit 4 detects the voltage of the measuring resistor 7, and the electric leakage discrimination circuit 6 detects the electric leakage of the battery pack 1 from the voltage of the measuring resistor 7.例文帳に追加

この漏電検出回路は、制御回路5が回路ブロック3のスイッチング素子8を順番に切り換え、抵抗電圧検出回路4が測定抵抗7の電圧を検出し、漏電判別回路6が測定抵抗7の電圧から組電池1の漏電を検出する。 - 特許庁

例文

A constant current I1 is made flow from a mirror circuit 2 connected to a current source 1 to the reference resistor R, and a voltage value generated in the reference resistor R is measured by a voltage measuring circuit 7.例文帳に追加

電流源1に接続されたミラー回路2から前記基準抵抗素子Rに定電流I1を流して、基準抵抗素子Rに生じる電圧値を電圧測定回路7により測定する。 - 特許庁

>>例文の一覧を見る


RESISTOR 1 CIRCUIT INのページの著作権
英和・和英辞典 情報提供元は 参加元一覧 にて確認できます。

   

ピン留めアイコンをクリックすると単語とその意味を画面の右側に残しておくことができます。

こんにちは ゲスト さん

ログイン

Weblio会員(無料)になると

会員登録のメリット検索履歴を保存できる!

会員登録のメリット語彙力診断の実施回数増加!

無料会員に登録する

このモジュールを今後表示しない
みんなの検索ランキング
閲覧履歴
無料会員登録をすると、
単語の閲覧履歴を
確認できます。
無料会員に登録する
英→日 日→英
こんにちは ゲスト さん

ログイン

Weblio会員(無料)になると

会員登録のメリット検索履歴を保存できる!

会員登録のメリット語彙力診断の実施回数増加!

無料会員に登録する

©2024 GRAS Group, Inc.RSS