quantity-drivenとは 意味・読み方・使い方

The throttle valve is adjusted in a suction quantity by being driven by a pulse motor.例文帳に追加

スロットル弁はパルスモータにより駆動されて吸気量が調節される。 - 特許庁

ELECTROMAGNETIC DRIVING DEVICE, ELECTROMAGNETICALLY DRIVEN LIGHT QUANTITY CONTROLLER AND OPTICAL DEVICE INCORPORATING THE SAME ELECTROMAGNETIC DRIVING DEVICE例文帳に追加

電磁駆動装置、この電磁駆動装置を組込んだ電磁駆動光量調整装置及び光学機器 - 特許庁

Then the motor 4 is driven for rotation by a controller 8 from the rotational quantity of the driving pulley 1 counted by the counter 7 until the rotational quantity reaches a target value.例文帳に追加

このカウンタ７での駆動プーリ１の回転量を元に制御コントローラ８によって目標移動量までモータ４を回転駆動させる。 - 特許庁

To control the quantity of ventilation into a desired appropriate quantity of ventilation by automatically measuring the duct loss resistance on the site, at ventilation with a motor-driven fan.例文帳に追加

電動ファンでの換気時、現場のダクト損失抵抗を自動測定し所望の適性換気風量に制御する装置。 - 特許庁

The push-in set quantity of the foamed rubber roller 1 is added to the measured gap quantity to calculate the push-in quantity from the position where the gap quantity is measured and the motor 8 is further driven to raise the foamed rubber roller 1.例文帳に追加

測定された隙間量に発泡ゴムローラー１の押込み設定量を加算することで、前記隙間量を測定した位置からの押込み量を算出し、さらにモーター８を駆動して発泡ゴムローラー１を上昇させる。 - 特許庁

In a complete priority mode of the bypass valve, the bypass valve is independently driven first on the demand drive quantity of the bypass valve, and after the complete stop, the water quantity regulating valve is independently driven in the remaining time within one cycle.例文帳に追加

バイパス弁完全優先モードでは、バイパス弁の要求駆動量について先に単独駆動させ、完全停止後に１周期内の残時間で水量調整弁を単独駆動させる。 - 特許庁

The maximum quantity of deformation of a chock hole 15, by which the rotation of a bearing 16 is not hindered is calculated, the maximum value (optimum driving quantity) of the driving quantity of the cotter, which is not larger than the calculated maximum quantity is calculated and the cotters 18 are driven so as to be the calculated optimum driving quantity.例文帳に追加

ベアリング１６の回転を阻害しないチョック穴１５の最大変形量を算出し、その算出した最大変形量以下となるコッター打ち込み量の最大値（最適打ち込み量）を算出し、算出した最適打ち込み量となるようにコッター１８を打ち込む。 - 特許庁

The initial value is multiplied with a shift quantity coefficient, the shift quantity coefficient is changed in order as a variable, the calculated relation between the rotation quantity and the time in the driven shaft is compared with the measured relation between the rotation quantity and the time, and total value of differences of the respective rotation quantities is minimized to determine the shift quantity coefficient.例文帳に追加

前記初期値にシフト量係数をかけシフト量係数を変数として順次変化させ、算出従動軸回転量と時間との関係と計測回転量と時間との関係とを比較し、各回転量の差分の合計値を最小にすることでシフト量係数を決定する。 - 特許庁