意味 | 例文 (42件) |
基準圧力計の英語
追加できません
(登録数上限)
英訳・英語 standard pressure gauge
「基準圧力計」の部分一致の例文検索結果
該当件数 : 42件
気体供給手段から気体の供給を開始する際に、基準圧力計及び校正対象圧力計に加わる圧力に大きな圧力変動がもたらされることを回避して、基準圧力計及び校正対象圧力計に及ぼす影響を低減する。例文帳に追加
To reduce the effect on a reference pressure gauge and a pressure gauge to be calibrated by avoiding large pressure variation in the pressure applied to the reference pressure gauge and the pressure gauge to be calibrated when the supply of a gas is started from a gas supply means. - 特許庁
計測点P1に水槽2を設置し、基準点P2に圧力計3を設置する。例文帳に追加
A water tank 2 is installed at a measuring point P1 and a manometer 3 at a reference point P2. - 特許庁
基準ブリルアン計測又は基準レイリー計測によって、基準部材についての体積変化と単位圧力当たりの周波数シフト量との関係が把握される。例文帳に追加
Relation between a volumetric change and a frequency shift amount per unit pressure concerning a reference member is obtained by reference Brillouin measurement or reference Rayleigh measurement. - 特許庁
差圧計7に耐圧以上の圧力がかかり破損することを防ぐため、基準圧力6と測定圧力4との過大圧力差から差圧計7を保護するための電磁弁9を設ける。例文帳に追加
The pressure control device includes an solenoid valve 9 for protecting the differential pressure gage 7 from excessive pressure difference between the reference pressure 6 and the measurement pressure 4 in order to prevent the differential pressure gage 7 from being given any pressure which is equal to or more than a pressure resistance and damaged. - 特許庁
このときに、燃料ガス循環供給系の閉空間内の圧力を圧力計で検出し、該圧力計の検出結果が、基準以上の速度での圧力降下を示す場合には、燃料ガス漏れの発生を判定する(S5〜S7)。例文帳に追加
At this point pressure in a closed space of the fuel gas circulating supply system is detected by a pressure gage, and when the detection result of the pressure gage shows pressure drop at a reference speed or faster, the leakage of the fuel gas is determined (S5-S7). - 特許庁
基準圧力の両側の二つの圧力領域において異なる態様で表示可能な圧力計において、従来よりも圧力指示特性を向上させる。例文帳に追加
To improve a pressure indication characteristic of a pressure gauge displaying different manners in two pressure regions on the opposite sides of a reference pressure, compared to conventional ones. - 特許庁
計測ユニット21の距離センサ22は、CRDハウジング35を基準として原子炉圧力容器38の内壁までの距離を計測する。例文帳に追加
The distance sensor 22 of the measurement unit 21 measures the distance to the inside wall of the reactor pressure vessel 38, referred to the CRD housing 35. - 特許庁
-
履歴機能過去に調べた
単語を確認! -
語彙力診断診断回数が
増える! -
マイ単語帳便利な
学習機能付き! -
マイ例文帳文章で
単語を理解!
「基準圧力計」の部分一致の例文検索結果
該当件数 : 42件
圧力分布センサ11からの圧力分布データに基づいて、重心算出部133が重心位置を検知時刻ごとに算出し、基準位置算出部136が被計測者と圧力分布センサ11との接触領域の中心である基準位置を検知時刻ごとに算出する。例文帳に追加
A gravity center calculating part 133 calculates positions of the center of gravity on detecting times based on pressure distribution data from a pressure distribution sensor 11 and a reference position calculating part 136 calculates the reference position which is the center of an area of bringing the subject into contact with the pressure distribution sensor 11 on detecting times. - 特許庁
圧力計測装置23は、圧力検出センサ22により検出された圧力と、予め設定しておいた基準値とを比較することにより、薬液補充ポンプ17が正常に動作しているか否かを判断する。例文帳に追加
A pressure-measuring device 23 compares a pressure detected by the pressure-detecting sensor 22 with a pre-set reference value, for determining whether the chemical-liquid refilling pump 17 is operating normally. - 特許庁
高さ表示装置5は、圧力計3の計測圧力PVから計測点P1と基準点P2との2点間の高さHを求め、高さ表示部5−1にデジタル値で表示する。例文帳に追加
A height display devices 5 determines a height H between two of the measuring point P1 and the reference point P2 from a measured pressure PV of the manometer 3 to be displayed in a digital value on a height display part 5-1. - 特許庁
吸気圧力波の基本周波数と検出したエンジン回転数NEから、理論式を用いて基準吸気温度での同調次数を計算する。例文帳に追加
Tuning degree at reference intake temperature is calculated using a theoretical expression from basic frequency of intake pressure wave and detected number of revolutions of an engine NE. - 特許庁
血圧計100では、所定の状態における圧力センサ131の出力値と基準値とを比較することにより、圧力センサ131の劣化の段階が決定される。例文帳に追加
In the blood pressure measuring device 100, the degree of deterioration of the pressure sensor 131 is determined by comparing the output value of the pressure sensor 131 in a specific state with a reference value. - 特許庁
次に、プランジャ12を動作させて、計量室9に設けた圧力検出センサ10により検出される圧力検出値を記憶部19に記憶された基準値にする。例文帳に追加
A plunger 12 is actuated so that a pressure value detected by a pressure detection sensor 10 provided in the measurement chamber 9 becomes a reference value stored in a memory part 19. - 特許庁
上流側配管と下流側配管との連通が遮断された状態から二次圧力計によって所定の圧力変化が検出されるまでのメインバルブの実変位量を基準変位量として記憶する。例文帳に追加
The actual displacement amount of the main valve from the state where the communication between the upstream pipe and the downstream pipe is blocked until the secondary pressure gauge detects a predetermined pressure change is stored as a reference displacement amount. - 特許庁
差圧計7にて基準圧力6と測定圧力4との差圧を測定し、制御コントローラ8の制御指令に従い、ノズルフラッパ弁3を開閉することで、制御対象2に供給される流体圧力を制御する。例文帳に追加
The pressure control device measures a differential pressure between a reference pressure 6 and a measurement pressure 4 by a differential pressure gage 7, and opens/closes a nozzle flapper valve 3 according to the control command of a control device 8 to thereby control the pressure of fluid to be supplied to a control object 2. - 特許庁
|
意味 | 例文 (42件) |
|
ピン留めアイコンをクリックすると単語とその意味を画面の右側に残しておくことができます。 |
ログイン |
Weblio会員(無料)になると 検索履歴を保存できる! 語彙力診断の実施回数増加! |
weblioのその他のサービス
ログイン |
Weblio会員(無料)になると 検索履歴を保存できる! 語彙力診断の実施回数増加! |