FRONT END OF LINEとは 意味・読み方・使い方

Since the front joint section is extended from a front end edge 27 to the side of an intermediate portion 32 through a front center line r-r, in the front portions 39a and 40a, front maximum points 41 and 42 maximizing an interval W2 between them are formed on the side of the intermediate portion rather than the front center line r-r.例文帳に追加

前方接合部位は前端縁２７から前方中心線ｒ−ｒよりも中間部分３２側にまで延びているので、前方部３９ａ，４０ａにおいては前方中心線ｒ−ｒよりも中間部分３２側で、これらの間隔Ｗ２を最大とする前方最大点４１，４２が形成される。 - 特許庁

A line (or another kind of string) is fixed to the fixing tool of (1) and the line (or the other kind of string) is passed through a tool at the front end of (2).例文帳に追加

（１）の固定器具に糸（その他のひも）を固定して、（２）の先端部の器具に糸（その他のひも）を通す。 - 特許庁

However, a flat surface 51 is located on the outer peripheral side surface of the grounding electrode 27 and has a length of 0.2 mm or more from a front end surface at the side of an axis line CL1 at the front end part at the side of the axis line CL1.例文帳に追加

但し、接地電極２７のうち外周側面であって、軸線ＣＬ１側の先端部分には軸線ＣＬ１側の先端面から０．２ｍｍ以上の長さを有する平坦面５１が形成されている。 - 特許庁

The interval Wa between the line La and the line Lb in the front and rear directions of the head is 25-35% of the width W of the head being the length from the line La to the rearmost end E of the head in the front and rear directions.例文帳に追加

境界線Ｌａと稜線Ｌｂとの前後方向の間隔Ｗａを、境界線Ｌａからヘッドの最後端点Ｅまでの前後方向長さであるヘッド巾Ｗの２５〜３５％とする。 - 特許庁

In the patch array antenna, a feeder line 2 is formed on a first dielectric substrate 1 and a stub 3 is connected to the front end of the line 2.例文帳に追加

第１の誘電体基板１上に給電線路２が形成され、その先端にスタブ３が接続されている。 - 特許庁

Since at least the tip end axial line of the front torch 2f and the rear torch 2r is in the truncated chevron, the axial line of the rear torch 2r is more inclined, in the tip end side, than the front torch 2f in the direction forward in the torch advancing direction.例文帳に追加

前トーチ２ｆと後トーチ２ｒの少なくとも先端部の軸線が逆ハ字状を呈していることから、後トーチ２ｒの軸線は、その先端側がトーチ進行方向前方となる方向に前トーチ２ｆより更に傾斜する。 - 特許庁

A cut line 3 is formed from near the bottom end section of the back surface part fabric to the bottom end near both right and left side edges of the front surface part fabric.例文帳に追加

前面部生地の左右両側縁部近傍で、かつ、背面部生地の下端部位の近傍から下端部に及んで切線３を形成する。 - 特許庁

The vehicle 1 is allowed to retreat by the amount, where a predicted track T of a left rear wheel is in contact with a front frame line entry end S0 in a parking frame S, and is stopped at a position P2, where a rear wheel reaches the front frame line entry end S0.例文帳に追加

左側後輪の予想軌跡Ｔが駐車枠Ｓの前側枠線入口端Ｓ０に接する操舵量で車両１を後退させ、後輪が前側枠線入口端Ｓ０に達した位置Ｐ２で停止する。 - 特許庁