「低位」を含む例文一覧(570)

1 2 3 4 5 6 7 8 9 10 11 12 次へ>
  • 低位耳介
    lowset ears  - 日本語WordNet
  • 低位のビット
    the low-order bit  - コンピューター用語辞典
  • 高位[低位]サロゲート《⇒surrogate code point》
    a high [low] surrogate  - 研究社 英和コンピューター用語辞典
  • 低位相雑音増幅回路
    AMPLIFIER CIRCUIT WITH REDUCED PHASE NOISE - 特許庁
  • 物価は低位安定している。
    Prices remain stable and low. - 経済産業省
  • LED低位置照明方式及びLED低位置照明装置
    LED LOW POSITION ILLUMINATION SYSTEM AND LED LOW-POSITION ILLUMINATOR - 特許庁
  • 余裕資金の投資先として低位株を物色している。
    I am looking for low-priced stocks as an investment of excess cash. - Weblio英語基本例文集
  • 低位相雑音化回路及び高周波発振源
    LOW PHASE NOISE CIRCUIT AND HIGH FREQUENCY OSCILLATION SOURCE - 特許庁
  • 低位相雑音の高周波発振器を提供すること。
    To provide a high frequency oscillator with low phase noise. - 特許庁
  • 低位浮上高さスライダの設計態様
    DESIGN ASPECT OF ULTRA-LOW LEVEL SURFACING HEIGHT SLIDER - 特許庁
  • 低位相速度のための構造、方法、および設計構造(低位相速度のためのミリメートル波伝送線)
    STRUCTURE, METHOD, AND DESIGN STRUCTURE FOR SLOW PHASE VELOCITY (MILLIMETER WAVE TRANSMISSION LINE FOR SLOW PHASE VELOCITY) - 特許庁
  • 書き込みのための情報がFIFOメモリ24に格納されると、低位バスマスタ回路23が低位バス18に順次データを独自に転送する。
    The low-order bus master circuit 23 independently transfers data sequentially to the low-order bus 18, when the data for writing are stored in the FIFO memory 24. - 特許庁
  • 凸部11の径方向内側は、凸部11の頂部よりも封止面7側に低位低位面15となっている。
    The radial direction inside of the projection part 11 is a lower face 15 on the side of the sealing face 7 than the top part of the projection part 11. - 特許庁
  • キーユニット(12)のキートップ(30)は、低位置と当該低位置より高い突出位置との間で移動可能である。
    A key top (30) of a key unit 12 is movable between a low position and a projecting position higher than the lower position. - 特許庁
  • DICOMは, より低位層のトランスポート・プロトコルとしてTCP/IPを使っている.
    DICOM (digital imaging and communication in medicine) uses TCP/IP as the lower-layer transport protocol.  - コンピューター用語辞典
  • このコマンドは,ビットを一つカーソルの上(次に低位のビット)へ挿入する
    This command inserts a bit above the cursor(next lower-order bit)  - コンピューター用語辞典
  • 低位側の 8 ビットが 18 以上だと、拡張状態データ (extended sense data)が用いられる。
    If the lowest eight bits are >= 18, bits from the extended sense data are used.  - JM
  • 基板11は、低位部11aと高位部11bを有している。
    A substrate 11 has a lower order section 11a and a higher order section 11b. - 特許庁
  • 小型で低位相雑音特性を有するマイクロ波発振器を実現する。
    To provide a small-sized microwave oscillator provided with low phase noise characteristics. - 特許庁
  • パケットの転送先となる端末を、より低位レイヤーで切り替える。
    To switch a terminal being a packet transfer destination in a lower layer. - 特許庁
  • 低位置から高位置まで段階的に手すり2、3を配置する。
    Handrails 2 and 3 are placed stepwise from lower to higher positions. - 特許庁
  • 低位部を有する木質床材の少なくとも低位部に塗布材を塗布してなる塗装木質床材の製造方法において、低位部に確実に塗布材を塗布できる製造方法を提供する。
    To provide a method of manufacturing painting woody floor material having a low position part that exactly coats the low position part of the woody floor material with a coating material in the method of manufacturing the painting woody floor material made by coating at least the low position part of the woody floor material having the low position part with the coating material. - 特許庁
  • ガレージ床面31は中央側が低位部となるように形成されており、その低位部には、底面におけるガレージ開口部33側が低位部となるように第1排水溝51が設けられている。
    The garage floor surface 31 is formed so as to have a lower height portion at the center, and the lower height portion has a first drain ditch 51 formed in a bottom surface thereof so as to be lower on the side of a garage opening section 33. - 特許庁
  • 太陽光パネル22は低位側パネル脚部25及び高位側パネル脚部26により支持されており、それら低位側パネル脚部25及び高位側パネル脚部26は低位側支持レール31及び高位側支持レール32により支持されている。
    The solar panels 22 are supported by lower-side panel leg parts 25 and higher-side panel leg parts 26, and the lower-side panel leg parts 25 and the higher-side panel leg parts 26 are supported by lower-side support rails 31 and higher-side support rails 32. - 特許庁
  • 小文字は大文字と同じに扱われる。 月の名称にない文字列は、より低位であるとみなされる。
    If no key is given, use the entire line as the key.  - JM
  • マイナー番号の低位側の 5 ビットは、検出された順に割り当てられる。
    The lowermost five bits in the minor numbers are assigned sequentially in the order of detection.  - JM
  • 小文字は大文字と同じに扱われる。 月の名称にない文字列は、より低位であるとみなされる。
    Invalid names compare low to valid names.  - JM
  • ローコスト、低位相ノイズ、かつ、低消費電力の発振器を提供する。
    To provide the oscillator which is low-cost and has low phase noise and low power consumption. - 特許庁
  • この低位置において、移動ローラ23が床17に接し、座椅子1全体を移動可能になる。
    In this low position, the transfer roller 23 comes into contact with a floor 17 and hence, the entire legless chair 1 can be made transferable. - 特許庁
  • その際、ポンプの吸込み管(7)を上向きにし、低位(B)の水槽(1)の底へ取付けた。
    At that time, the sucking pipe 7 is turned upward, and attached to a bottom of a water tank 1 at a low position B. - 特許庁
  • 高硬度部3aと低硬度部3bとの境界面は、後方ほど低位となる斜面となっている。
    A boundary face between the high hardness part 3a and the low hardness part 3b is an inclined face becoming lower position as it comes backward. - 特許庁
  • また、領域Yにおいては、シール材70が低位側電位供給線VSaの一部と重なる。
    Further, in the area Y, a seal material 70 overlaps with a part of the low potential side potential supply line VSa. - 特許庁
  • 地表レベルG.L付近の低位置で、ゲート開閉機10によりゲート扉体6を開閉させる。
    The gate door 6 is opened/closed at a low position near a ground surface level G.L by the gate opening/closing machine 10. - 特許庁
  • 気体燃料の低位発熱量およびウォッベ指数を測定するための方法、センサ、およびシステム
    METHOD, SENSOR, AND SYSTEM FOR MEASURING WOBBE INDEX AND LOWER HEATING VALUE OF GAS FUEL - 特許庁
  • 適度な短期安定性及び精度の低位相ノイズ高速タイムベースを提供すること。
    To provide an inexpensive low phase noise high-speed time base with suitable short time stability and accuracy. - 特許庁
  • 低位置孔19とソール7との距離Xの全長Yに対する比率は、15%以下である。
    Ratios of the distance X between the low level holes 19 and the sole 7 to the full length Y is 15% or less. - 特許庁
  • 本発明は、走行車体1に設けた刈取フレ−ム2の低位置に刈取装置3を装備して設けた。
    This reaping apparatus 3 is installed at the lower position of a reaping frame 2 attached to a traveling body 1. - 特許庁
  • 洗浄機を低位置に設置できる洗浄水循環ユニットを提供する。
    To provide a cleaning water circulating unit in which a cleaning machine is installed at a low position. - 特許庁
  • ユーザ指定可能、低コスト、低位相跳躍、かつスペクトル純度の高いチューナブル発振器
    USER-DEFINABLE, LOW COST, LOW PHASE HIT AND SPECTRALLY PURE TUNABLE OSCILLATOR - 特許庁
  • 接合工具20の回転子21の回転軸線Qを、低位側の接合部材1側に傾斜させる。
    A rotary shaft line Q of a rotor 21 of a joint tool 20 is inclined on a joint member 1 side on the lower side. - 特許庁
  • 支持脚(6)の上端を板状部(2)の上面(4)よりも低位置に配置する。
    The upper ends of the supporting legs (6) are disposed at a lower position than an upper surface (4) of the tabular section (2). - 特許庁
  • 低位相雑音で出力周波数帯域が広帯域な電圧制御発振器を提供すること。
    To provide a voltage controlled oscillator which has low phase noise and a broad frequency band. - 特許庁
  • 空気室14を液槽11と分離して底面を液槽底面よりも低位置に設置する。
    The air room 14 is separated from the liquid tub 11 and the bottom of the air room is set lower than the bottom of the liquid tub. - 特許庁
  • プリンタコントローラはまた、取り消されている印刷ジョブに対してより低位の優先度を割り当てる。
    The printer controller allocates a lower priority to the canceled printing job. - 特許庁
  • 回収樋に場合には、底面中央の最低位置に導電性被膜6を形成する。
    In the case of a recovery gutter, the conductive film 6 is formed at a lowest position at the center of the bottom surface. - 特許庁
  • また、「工業用素材」や「農林水産」といった業種は5年間低位で推移している。
    Also, rates for "industrial materials" and "agriculture, forestry, and fisheries" ranked the lowest of all industries during the five years. - 経済産業省
  • (国際的な過剰流動性の増加要因①:金融緩和と長期金利の低位安定)
    (Factors behind an increase in international excessive liquidity (1): monetary relaxation and long-term interest rates which have remained low for a long time) - 経済産業省
  • 高Qの共振回路を用いることなく、電気信号の低位相雑音化を図ることができる低位相雑音化回路及び高周波発振源を得ることを目的とする。
    To obtain a low phase noise circuit capable of making an electric signal have low-phase noise without using a high Q resonance circuit, and a high frequency oscillation source. - 特許庁
  • 材料をダンサー最低位置におき、送り出し速度を0とし、この状態から、架空の初期巻径から巻取り制御を行なうと、材料はダンサー位置は最低位置から中央へ徐々に移動して行き、巻取機は停止する。
    The material is placed in the dancer lowest position, and the sending-out speed is set to 0, and when performing winding control from an imaginary initial winding diameter from such a state, the material gradually moves to the center from the lowest position in a dancer position, and the winder stops. - 特許庁
  • ヒートパイプ2のコンテナ7内に、左右方向に伸びる低位部9aと、低位部9aの左右両端部に連なった高位部9cとを有する中空回路9を形成する。
    In the container 7 of the heat pipe 2, a hollow circuit 9 having a lower part 9a extending in the right-left direction and a high part 9c continuing from both right and left end parts of the lower part 9a are formed. - 特許庁
1 2 3 4 5 6 7 8 9 10 11 12 次へ>

例文データの著作権について