「Fasteners」の共起表現(1語右で並び替え)

Weblio 辞書 > 英和辞典・和英辞典 > Fastenersの意味・解説 > Fastenersに関連した共起表現

意味

例文

共起表現

「Fasteners」の共起表現一覧(1語右で並び替え)

該当件数 : 26件

nd slat track components, and titanium alloy	fasteners, among other uses.
rom the second stage by means of pyrotechnic	fasteners and pneumatic actuators.
Fortune 200 company that produces engineered	fasteners and components, equipment and consumable sys
arated into the Amish (who used hook-and-eye	fasteners) and the followers of Reist (who used button
ercial products, such as sputtering targets,	fasteners and dental implants, are already available.
These	fasteners are said to have a "center pin reject" featu
re screws, nails, adhesives, or other simple	fasteners are either impractical or ineffective.
5 degrees) and ISO Metric (60 degrees) so BA	fasteners are never interchangeable with Whitworth/Met
ould be the SAE thread standard for threaded	fasteners based on the USS standard but with a finer t
For screws and	fasteners, case hardening is less complicated as it is
attaching light close-outs, removing launch	fasteners, connecting to U.S. Laboratory resources and
ntisubsidy investigations on stainless steel	fasteners from Malaysia and the Philippines, as well a
jects used as ornaments or seals rather than	fasteners have been discovered in the Indus Valley Civ
7/32" BSF in assemblies that included larger	fasteners, however, in smaller equipment that was prim
at they had reached a settlement with Powers	Fasteners, in which they would be paid $6 million.
gear wheels, ski bindings,	fasteners, lock systems) and the material is widely us
Director, SSundram	Fasteners Ltd.
	Fasteners on the left side upstop/guide wheel on the f
to drive SAE, metric and other thread system	fasteners, reducing the number of bit sizes required.
The	fasteners securing faucets and other connections under
It defines mechanical properties for	fasteners that range from M1.6 to 100 in diameter.
These two additional standards are	fasteners that have the same mechanical properties as
roughout the aerospace industry, countersunk	fasteners typically have an angle of 100°.
This standard defines the properties for	fasteners up to 4 inches in diameter.
In 1898, the standard for metric threaded	fasteners was established.
tandard for quarter inch and larger threaded	fasteners was adopted on November 18, 1948, and was su

共起表現

「Fasteners」の共起表現(1語右で並び替え) - Weblio英語共起表現検索

「Fasteners」の共起表現一覧(1語右で並び替え)