「WORK PIECES」の共起表現一覧(1語右で並び替え)
該当件数 : 29件
For some thinly coated | workpieces a chromate passivation is necessary. |
There is the resistance of the | workpieces, and the contact resistance between the work |
n a gas- or oil-fired soaking pit for larger | workpieces and for smaller workpieces induction heating |
ich optimize the flow coefficient of certain | workpieces, and the perfectly-formed, tangentially-blen |
To minimize distortion, long cylindrical | workpieces are quenched vertically; flat workpieces are |
g filing takes place on a flat surface where | workpieces are fed into the file. |
Sometimes the | workpieces are finished against each other; however, us |
as either batch systems, in which batches of | workpieces are added, run, and removed before the next |
he trivalent chromium plating process plates | workpieces at a similar temperature, rate and hardness, |
require more than one pass for welding thick | workpieces, but often a single pass is sufficient for e |
A vacuum table is a system for holding | workpieces during machining. |
Commonly plated | workpieces include nails, screws, nuts, washers, stampi |
Examples of | workpieces included automotive steering knuckles and tr |
On non-coated | workpieces marking blue is commonly used to increase th |
Tools and | workpieces may also cause damage when dropped on the su |
are oftentimes used when a large quantity of | workpieces must be inspected. |
For example, several | workpieces need a slot, a flat surface, and an angular |
can be as short as 10 minutes for nonferrous | workpieces or as long as 2 hours for hardened steel. |
d tool used in metalworking to mark lines on | workpieces, prior to machining. |
e was an automatic lathe tailored to cutting | workpieces that were mounted on centers (tools with poi |
at is inserted into the existing hole in the | workpieces; the other component is the cutter, which is |
n the engineering field to level machines or | workpieces, the lower image shows an adjustable precisi |
lso be sequenced, which involves running the | workpieces through multiple different mass finishing pr |
Cutting | workpieces to length is usually done with a bandsaw. |
The | workpieces to be joined are treated with cleaning flux. |
Simple operation - heat the salt and | workpieces to temperature and submerge until the durati |
of the welding arc causes the electrode and | workpieces to melt and flow into the cavity between the |
Chain drives are used to draw | workpieces up to 30 m (98 ft). |
All the completed | workpieces would be the same. |
こんにちは ゲスト さん
ログイン |
Weblio会員(無料)になると 検索履歴を保存できる! 語彙力診断の実施回数増加! |
こんにちは ゲスト さん
ログイン |
Weblio会員(無料)になると 検索履歴を保存できる! 語彙力診断の実施回数増加! |