「tolerances」の共起表現一覧(1語右で並び替え)
該当件数 : 37件
Very wide | tolerances allowable (not very precise) |
They are made to close | tolerances and are therefore suitable for use in situat |
ssion molding uses a closed mold, so smaller | tolerances and more intricate parts can be achieved. |
manufacture fibers with semiconductor level | tolerances and microscopic layers in a scalable manner. |
red to as the “voice of the process”), while | tolerances and specifications describe how the product |
Close | tolerances are possible as springback can be significan |
For most lathe boring applications, | tolerances are held within ±0.002 in (±0.05 mm) for dee |
Typical | tolerances are 0.005 mm/mm or in/in because the sand co |
h as Greg Lightfoot have remarked that these | tolerances are what makes the factory knives so close t |
and 80% above rated value, although tighter | tolerances are available. |
Steel dowel pins are machined to tight | tolerances, as are the corresponding holes, which are t |
For precision applications, | tolerances can be held within ±0.0005 in (±0.013 mm) on |
is as the material is laid down, the feature | tolerances can be managed well. |
Within | tolerances, firing can be undertaken at lower temperatu |
The human body has different | tolerances for g-forces depending on the acceleration d |
The | tolerances for error were much finer than any other sta |
s are ground and polished to specified close | tolerances, free of distortion and resistant to changes |
ncreasing part life, decreasing wear, closer | tolerances, higher load bearing surfaces, better sealin |
try of these rolls is determined by specific | tolerances in addition to the type of material and work |
ver Redux 775/Powder 775, allowing for wider | tolerances in component-fit, as well as easier handling |
Soil | tolerances include clay, loam, sand, slightly alkaline, |
any Taiwanese or Chinese brands) in terms of | tolerances, inspection, features, and rigidity. |
designed to achieve the desired dimensional | tolerances of the forged parts. |
facturer claims that the small manufacturing | tolerances of 0.026 millimetres (0.0010 in) for the alu |
namic instability of the system demands high | tolerances of the track, which can offset, or eliminate |
auging limit based on the minimum or maximum | tolerances of the inspected part. |
d to high a standard and was made with tight | tolerances, raising costs but improving reliability and |
Because of the tight | tolerances required by these slip in pockets and the wa |
test engineers track product configurations, | tolerances, test sequences, and software being used by |
t in order to make a track with the required | tolerances, the gap between the magnets and rail would |
excellent surface finish, close dimensional | tolerances, thin cross-sections, and intricate shapes c |
suggested that different races had different | tolerances to climate and disease. |
le for wine production while still providing | tolerances to climatic, soil, and disease conditions th |
Invar, to prevent temperature from changing | tolerances too much. |
nditions due to issues with poor dimensional | tolerances, which gave the weapon a bad reputation with |
he pump diode (therefore allowing for higher | tolerances), wider absorption band, lower lasing thresh |
is widely used by Starrett-Webber gage block | tolerances, with a thermal expansion coefficient of 4.7 |
こんにちは ゲスト さん
ログイン |
Weblio会員(無料)になると 検索履歴を保存できる! 語彙力診断の実施回数増加! |
こんにちは ゲスト さん
ログイン |
Weblio会員(無料)になると 検索履歴を保存できる! 語彙力診断の実施回数増加! |