例文 (2件) |
線形入力拘束の部分一致の例文一覧と使い方
該当件数 : 2件
次に、超平面に拘束された時の線形モデルの制御入力のみを用いた場合の出力と、スライディング・モードの制御入力を用いた場合の出力との間の差分について、3次モーメントと、4次モーメントという高次統計量を計算する。例文帳に追加
Next, regarding a difference between output in the case where only control input of a linear model restricted by the hyperplane is used, and output in the case where control input of a sliding mode is used, a higher-order statistic of a third-order moment and a fourth-order moment are calculated. - 特許庁
制御手段に相当する最小ビット誤り率規範制御回路29は,伝送路のインパルス応答の推定値と受信機の信号対雑音比を入力し、最尤検出を行った際のビット誤り率を最小にするように,線形処理回路28の重み付け係数を拘束条件の下制御する。例文帳に追加
A minimum bit error rate reference control circuit 29 equivalent to a control means inputs an impulse response estimate of a transmission path and a signal-to-noise ratio of a receiver, and controls a weighting coefficient of the linear processing circuit 28 under restriction conditions so as to minimize a bit error rate when most likelihood detection is carried out. - 特許庁
例文 (2件) |
Copyright © Japan Patent office. All Rights Reserved. |
ログイン |
Weblio会員(無料)になると 検索履歴を保存できる! 語彙力診断の実施回数増加! |
ログイン |
Weblio会員(無料)になると 検索履歴を保存できる! 語彙力診断の実施回数増加! |