alternating voltage amplifierとは 意味・読み方・使い方

An inverting amplifier 11 inverts this voltage in polarity to generate inverted voltage, and a synchronous rectification section 12 alternately extracts the applied voltage of the alternating current on which the noise voltage is superimposed and its inverted voltage synchronously with the alternating voltage for measurement, and synchronously rectifies the applied voltage of the alternating current.例文帳に追加

この電圧を反転増幅器１１により極性反転して反転電圧を生成し、同期整流部１２により前記測定用交流電圧に同期してノイズ電圧が重畳した前記交流の印加電圧とその反転電圧とを交互に切り出し、前記交流の印加電圧を同期整流する。 - 特許庁

An inverting amplifier circuit 20 of the alternating signal detector 1 inverts and amplifies the alternating current signal by induced voltage of the coil 11 and applies the alternating signal to the second electrode 13 through a resistor 41 and a capacitor 42 with low capacitance.例文帳に追加

また、交流信号検出装置１の、反転増幅回路２０は、コイル１１の誘起電圧による交流信号を反転増幅し、抵抗４１、低キャパシタンスのコンデンサ４２を介して、第２電極１３に印可する。 - 特許庁

A charge amplifier 2 converts an input signal from the measurement capacitor Ct into an alternating voltage 102 so as to input it to the multiplexer 3.例文帳に追加

チャージアンプ２は、測定キャパシタＣｔからの入力信号を交流電圧１０２に変換し、マルチプレクサ３に入力する。 - 特許庁

The output signal of the differential amplifier 6 is amplified with an alternating current amplifier 22, after it is rectified with a rectifying circuit 23 to be converted into direct current voltage, converted with a V/F converter 24, converted into a frequency signal proportional to direct current voltage, and taken in CPU 11 through an I/O interface 10.例文帳に追加

差動増幅器６の出力信号は、交流増幅器２２で増幅され、整流回路２３で整流されて直流電圧に変換された後、Ｖ／Ｆ変換器２４で変換直流電圧に比例した周波数信号に変換され、Ｉ／Ｏインターフェース１０を介してＣＰＵ１１に取り込まれる。 - 特許庁

An alternating current voltage signal in response to impedance between both the electrodes generated by the application of the pulse current is converted in the impedance with preamplifiers 5a, 5b to be differentially amplified with a differential amplifier 6.例文帳に追加

パルス電流の印加で発生した両電極間のインピーダンスに応じた交流電圧信号は、前置増幅器５ａ、５ｂでインピーダンス変換されて差動増幅器６で差動増幅される。 - 特許庁

The sensor S, a diode D and a load resistance R are connected in series to an alternating current source P, and a comparator 5 for switching between ON/OFF states of an output by comparing the voltage amplified by an operational amplifier 6 with a prescribed threshold is connected to both ends of the load resistance R through the operational amplifier 6.例文帳に追加

センサＳとダイオードＤと負荷抵抗Ｒを交流電源Ｐに直列に接続し、負荷抵抗Ｒの両端にオペアンプ６を介し、このオペアンプ６で増幅された電圧を所定のしきい値と比較して出力のオン、オフを切り換えるコンパレータ５を接続する。 - 特許庁