| 例文 |
IDE cableの部分一致の例文一覧と使い方
該当件数 : 11件
Most IDE drives also have a Cable Select jumper. 例文帳に追加
多くの IDE ドライブはケーブルセレクト ジャンパを持っています。 - FreeBSD
Ideally, each IDE disk would have its own IDE controller and cable, but to minimize cost, additional IDE controllers were not used. 例文帳に追加
各 IDE ディスクがそれぞれの IDEコントローラとケーブルをもっていることが理想的ですが、 費用を最低限にするために、 IDEコントローラを追加していません。 - FreeBSD
METHOD FOR DISCRIMINATING 80 CONDUCTOR CABLE OF ATA SPECIFICATION IDE BUS例文帳に追加
ATA規格IDEバスの80芯ケーブル判別方法 - 特許庁
The IDE devices are configured for cable select connected to the IDE bus, wherein not more than two of the IDE devices are powered on at any given time.例文帳に追加
IDE装置はIDEバスに接続されるケーブル選択として構成され、どのような所与のときも、IDE装置のうちの2台までしか電源が入らない。 - 特許庁
The IDE HDD to be an extended equipment to be extended (g) is connected to a master IDE HDD through a signal cable (h) and power is supplied to the extended equipment (g) to be extended through a power supply cable (i).例文帳に追加
増設された増設機器gとしてのIDE HDDは、信号ケーブルhを介して図示しないマスターIDE HDDに接続され、電源は電源ケーブルiを介して供給される。 - 特許庁
The method connects and operates three or more devices to and on an IDE bus under the conditions that not more than two IDE devices may be active at any given time on the same IDE bus and that cable/trace lengths for the IDE bus may not exceed the limits set forth in the IDE bus standard.例文帳に追加
(1)どのような所与のときにも、同じIDEバス上で2台以下のIDE装置が活性化されている、(2)IDEバスについてのケーブル/トレース長は、IDEバス規格に示される制限を超えない、という条件下で、IDEバスに3台以上の装置を接続して動作させる方法。 - 特許庁
The terminals 41 and 42 in the second housing 4 are brought into contact with terminals 301a and 301b of an IDE cable 300.例文帳に追加
また、第2ハウジング4内部の端子41,42は、IDEケーブル300の端子301a,301bに接触するようになっている。 - 特許庁
An HDD fixing board 40 of simple structure and cables 51, 52 are used without a special IDE cable for connecting the control board 1 and the hard disk drives 20, 30.例文帳に追加
制御基板1とハードディスクドライブ20,30との接続用として、特殊なIDEケーブルを用いることなく、単純な構成のHDD取付基板40およびケーブル51,52を採用する。 - 特許庁
By mounting both connector portions of the hard disks back to back, not only connection by a cable based on the IDE specification is facilitated, but also workability of hard disk replacement is improved.例文帳に追加
ハードディスクのコネクタ部分同士を背中合わせに実装することで、IDE規格に準拠したケーブルでの接続を容易にさせるだけでなく、ハードディスク交換の作業性を向上させる。 - 特許庁
This HDD mounting substrate 40 of a simple configuration and cables 51 and 52 are adopted to connect the control substrate 1 and the hard disk drives 20 and 30 without using a special IDE cable.例文帳に追加
制御基板1とハードディスクドライブ20,30との接続用として、特殊なIDEケーブルを用いることなく、単純な構成のHDD取付基板40およびケーブル51,52を採用する。 - 特許庁
| 例文 |
| Copyright © Japan Patent office. All Rights Reserved. |
| この対訳コーパスは独立行政法人情報通信研究機構の研究成果であり、Creative Commons Attribution-Share Alike 3.0 Unportedでライセンスされています。 |
| Copyright 1994-2010 The FreeBSD Project. All rights reserved. license |
|
ログイン |
Weblio会員(無料)になると
|
|
ログイン |
Weblio会員(無料)になると
|