意味 | 例文 (44件) |
heat release rateとは 意味・読み方・使い方
追加できません
(登録数上限)
意味・対訳 熱発生率; 放熱速度; 熱放出速度
「heat release rate」の部分一致の例文検索結果
該当件数 : 44件
Knocking is judged (step 112) when the actual heat release rate and the estimated heat release rate are compared (step 108) and there is a section where difference between the actual heat release rate and the estimated heat release rate exceeds a knocking judgment line.例文帳に追加
実熱発生率と推定熱発生率とを比較し(ステップ108)、実熱発生率と推定熱発生率との差がノック判定ラインを超えている部分がある場合には、ノックと判定される(ステップ112)。 - 特許庁
Thus, the heat release rate in the combustion chamber 12 calculated by the heat release rate calculating unit 16, and the heat production amount calculated by integrating the heat release rate by a combustion mass ratio calculating unit 17 are reduced in an error after the second half of the combustion, in other words, the heat release rate reaches a peak.例文帳に追加
これにより、熱発生率算出部16で算出する燃焼室12における熱発生率、および燃焼質量割合算出部17で熱発生率を積分することにより算出する熱発生量は、燃焼の後半すなわち熱発生率がピークとなった以降における誤差が低減される。 - 特許庁
A rate of the heat release IHR of combustion corresponding to pilot injection is calculated, and the rate of the heat release IHR is converted into a cetane number CET of fuel.例文帳に追加
パイロット噴射に対応する燃焼の熱発生量IHRを算出し、熱発生量IHRを燃料のセタン価CETに変換する。 - 特許庁
When the rate of the heat release IHR is lower than a second set rate of heat release IHR2, a gain A is applied to perform conversion (S17), and when the rate of the heat release IHR is higher than the second set rate of the heat release IHR2, a gain B (>A) is applied to perform conversion (S26).例文帳に追加
熱発生量IHRが第2設定熱発生量IHR2以下であるときはゲインAを適用して変換を行い(S17)、熱発生量IHRが第2設定熱発生量IHR2より大きいときはゲインB(>A)を適用して変換を行う(S26)。 - 特許庁
The heat release rate QHR is subtracted from the target heat release rate QHRCMD to thereby calculate a heat release rate deviation DQHR, and the amount of fuel injected QIP2 in the second pilot injection INJP2 is calculated so that the heat release rate deviation DQHR is set to "0".例文帳に追加
目標熱発生量QHRCMDから熱発生量QHRを減算することにより熱発生量偏差DQHRを算出し、熱発生量偏差DQHRが「0」となるように第2パイロット噴射噴射INJP2における燃料噴射量QIP2を算出する。 - 特許庁
When the rate of heat release IHR exceeds the second set rate of heat release IHR2 from a state that it is lower than the second set rate of the heat release IHR2, transient control (S23, S25) is performed so that a gain A gradually reaches the gain B.例文帳に追加
熱発生量IHRが第2設定熱発生量IHR2以下の状態から、第2設定熱発生量IHR2を超えたときは、ゲインAを徐々にゲインBに近づける過渡制御を行う(S23,S25)。 - 特許庁
Heat release quantity Q is calculated by integrating the heat release rate dQ/dθ over combustion period.例文帳に追加
この熱発生率dQ/dθを燃焼期間中に渡って積分(積算)することにより、熱発生量Qを算出する。 - 特許庁
-
履歴機能過去に調べた
単語を確認! -
語彙力診断診断回数が
増える! -
マイ単語帳便利な
学習機能付き! -
マイ例文帳文章で
単語を理解!
「heat release rate」の部分一致の例文検索結果
該当件数 : 44件
To provide an aircraft window comprising a transparent pane which satisfies requirements of the peak heat release rate and the two min heat release of OSU 100/100.例文帳に追加
OSU100/100の最大発熱速度および2分発熱の要件を満たす透明窓ガラスを備える航空機の窓を開示する。 - 特許庁
Heat release rate per crank angle dQ/dθ is calculated based on cylinder pressure per crank angle.例文帳に追加
クランク角ごとの筒内圧Pに基づいて、クランク角ごとの熱発生率dQ/dθを算出する。 - 特許庁
METHOD FOR DETERMINING WIEBE FUNCTION PARAMETER AND DEVICE FOR PRESUMING HEAT RELEASE RATE OF INTERNAL COMBUSTION ENGINE例文帳に追加
Wiebe関数パラメータの決定方法および内燃機関の熱発生率推定装置 - 特許庁
Actual heat release rate is calculated at each crank angle based on measured cylinder pressure (step 104).例文帳に追加
計測した筒内圧に基づいて、クランク角度毎の実熱発生率を算出する(ステップ104)。 - 特許庁
A required nominal-torque heat-release-rate characteristic value that satisfies the required nominal torque, required engine speed, and required ignition timing is specified as the maximum value of a heat-release-rate waveform.例文帳に追加
要求図示トルク、要求回転数、要求着火時期を満たす要求図示トルク熱発生率特性値を燃焼率波形の最大値として規定する。 - 特許庁
To provide a method of estimating the heat release rate of an engine using a Wiebe function model, properly calculating function model parameters of a Wiebe function, thereby achieving a highly accurate estimation processing of the heat release rate.例文帳に追加
Wiebe関数の関数モデルパラメータを適切に算出でき、ひいては高精度の熱発生率の推定処理を実現できるWiebe関数モデルを用いたエンジンの熱発生率の推定方法を提供する。 - 特許庁
No-knocking is judged (step 114) when the difference between the actual heat release rate and the estimated heat release rate stays within the knocking judgment line all over.例文帳に追加
実熱発生率と推定熱発生率との差が全体に渡ってノック判定ライン以内に収まっている場合には、ノックでないと判定される(ステップ114)。 - 特許庁
A belt tubular body has a tubular heat-resisting resin layer and a release layer formed on the outer surface of the heat-resisting resin layer, and the heat-resisting resin layer and release layer are formed by burning after the heat-resisting resin layer is coated with the release layer in a state wherein the imide processing rate of the heat-resisting resin layer is 20 to 70%.例文帳に追加
管状の耐熱性樹脂層と、耐熱性樹脂層の外表面に形成された離型層とを有するベルト管状体であり、耐熱性樹脂層と離型層とは、耐熱性樹脂層のイミド化率が20〜70%の状態で離型層が塗布された後、焼成されて形成されている。 - 特許庁
|
意味 | 例文 (44件) |
|
ピン留めアイコンをクリックすると単語とその意味を画面の右側に残しておくことができます。 |
ログイン |
Weblio会員(無料)になると 検索履歴を保存できる! 語彙力診断の実施回数増加! |
-
1unmet
-
2destiny
-
3硬貨
-
4while
-
5consider
-
6leave
-
7present
-
8experience
-
9address
-
10appreciate
「heat release rate」のお隣キーワード |
weblioのその他のサービス
ログイン |
Weblio会員(無料)になると 検索履歴を保存できる! 語彙力診断の実施回数増加! |