「"弦線"」に関連した英語例文の一覧と使い方 - Weblio英語例文検索

高マッハ数側の入射角範囲の限界（＋４０°）により近い状態に整列するように、翼弦線６２は方向づけられる。例文帳に追加

The vane chord line 62 is directed so that they stand in a row in a condition closer to limit (+40°) of a scope of angle of incidence on a high mach number side. - 特許庁

ファンの回転中心である中心軸１０１および外縁部２７を通る直線３３６と、外縁部２７における中心線１０６の接線３３７とがなす角度を外周側翼先端角βと規定し、翼弦線３３３と、中心軸１０１および外周側翼先端部２９と翼弦線３３３との接点３３１を通る直線３３２とがなす角度を食違い角αと規定する。例文帳に追加

The angle which is formed by a straight line 336 passing through an outer edge 27 and a center axis 101 which is the rotational center of the fan and by a tangent 337 of a center line 106 in the outer edge 27, is specified as an outer peripheral side blade tip angle β. - 特許庁

翼弦線や前縁部の向き、流路７４の収束や湾曲の組合せにより、ベーン表面から分離せず、より高いマッハ数の流体が流路７４に流入する。例文帳に追加

Fluid having higher mach number is not separated from a surface of the vane and flows into a flow passage 74 by a combination of directions of the vane chord line and the leading fringe part and convergence and curving of the flow passage 74. - 特許庁

砥石３の端面の研磨時接触線を、砥石３の端面の中心孔の中心を通る直径線４、５乃至中心孔を外れない限度の直径線に平行する弦線４、５の範囲内にして研磨する。例文帳に追加

A contact line at the time of polishing an end face of the grinding wheel 3 is set in a scope of diameter lines 4, 5 passing through the center of a central hole at the end face of the grinding wheel 3 or chord lines 4, 5 parallel with a diameter line to such extent that it is not deviated from the central hole for polishing. - 特許庁

翼弦線６２は、前方端部５２の前縁から後方端部５６の後縁に直線的に延び、平均キャンバー線６４は、面４４と面４６との間を前縁から後縁に延びる。例文帳に追加

A vane chord line 62 is linearly extended to a trailing fringe of a trailing end part 56 from a leading fringe of a leading end part 52, and an average camber line 64 is extended from a leading fringe to a trailing fringe between a face 44 and a face 46. - 特許庁