compressive memberとは 意味・読み方・使い方

A tendon is arranged inside the steel frame member, and compressive stress is introduced into the jointing surface of the steel frame member.例文帳に追加

鋼枠部材の内側には、緊張材が配置され、鋼枠部材の接合面に圧縮応力が導入される。 - 特許庁

To exactly transmit tensile force and compressive force working on a fiber reinforced plastic member to a concrete member by jointing the fiber reinforced plastic member and the concrete member.例文帳に追加

繊維補強プラスチック部材とコンクリート部材とを接合し、繊維補強プラスチック部材に作用する引張力及び圧縮力をコンクリート部材に確実に伝達する。 - 特許庁

The first cushioning member 200 is comprised of a piston 201 and a compressive coil spring 202, the compressive coil spring 202 is arranged so as to energize the piston 201 on the coupling 6.例文帳に追加

この第１の緩衝部材２００は、ピストン２０１と圧縮コイルスプリング２０２からなり、圧縮スプリング２０２はピストン２０１をカップリング６に付勢するように配置する。 - 特許庁

The compressive stress is exerted in the mounting stay part 42 by the bolt-fastening to the coupling member 16.例文帳に追加

これにより、取付ステー部４２に、結合部材１６とのボルト締結によって圧縮応力を与える。 - 特許庁

To provide an air intake member to make deformation sufficiently even in case the load in the compressive direction is comparatively small.例文帳に追加

圧縮方向の荷重が比較的小さい場合にも充分に変形する吸気部材を提供する。 - 特許庁

Further, a curved member 20, to which a compressive load is applied, is attached in front of the longitudinal member 18 and is connected to a bumper reinforcement 22.例文帳に追加

さらに、圧縮荷重が付与された湾曲部材２０を、縦部材の前方に取り付けると共にバンパーリインホースメント２２に連結する。 - 特許庁

That is, even if the initial compressive axial force is loaded to the vibration control member 20, the initial compressive axial force is canceled by the tensile axial force produced by the shear deformation of the vibration control member not to lower the vibration energy absorbing performance of the vibration control member 20.例文帳に追加

即ち、制震部材２０に初期圧縮軸力を負担させても、この初期圧縮軸力が制震部材のせん断変形による引張り軸力によって打ち消されるため、制震部材２０の振動エネルギー吸収性能が低下しない。 - 特許庁

Between its right and left end member 2A, 2A, a steel pipe having the same outer diameter and a compressive yield strength larger than that of the end member is connected as a middle member 3A.例文帳に追加

その左右の端部材２Ａ，２Ａの間に、同一の外径を有して端部材よりも圧縮耐力の大きい鋼管が中間部材３Ａとして接続される。 - 特許庁