projecting lengthとは 意味・読み方・使い方

When the adjusting section 40 is moved forward and backward along the body 20 so that the gauge section 30 indicates the projecting length H0 of the required tool 4, the projecting length of the tool 4 held by the body 20 becomes the required projecting length H0'.例文帳に追加

このゲージ部３０が所望する工具４の突き出し長Ｈ０を示すように、本体部２０に沿って調整部４０を進退移動させると、本体部２０に保持される工具４は所望の突き出し長Ｈ０’になる。 - 特許庁

A length of the prepared hole 7 is longer than a projecting length L5 of the tapped screw 6 from the circuit board 17.例文帳に追加

回路基板１７からのタップねじ６の突出長さＬ_5 よりも下孔７の長さを長く設定した。 - 特許庁

A cable is hooked on a projecting part of a drum 4, and rotated to adjust its length.例文帳に追加

ドラム（４）の突起部へケーブルを引掛け、回転させて長さの調節をする。 - 特許庁

The projecting length X1 of the positive electrode foil 5 and the projecting length of the separators 3, 4 are set nearly a half of winding core width W and not larger than the winding core width W, respectively.例文帳に追加

プラス電極箔５がはみ出す長さＸ１が巻芯幅Ｗのほぼ半分で、セパレータ３，４がはみ出す長さが巻芯幅Ｗ以下に設定される。 - 特許庁

Furthermore, the projecting portions are formed at four points in conformity to bent portions, and the projecting portions are formed with a length equal to a radial length of flanges formed in a secondary coil.例文帳に追加

さらに、突部は曲部に沿うような形状で４箇所に形成され、突部は２次コイルに形成されるフランジの径方向の長さと同じ長さに形成されている。 - 特許庁

The projecting members are tapered in shape, and the heights H of the projecting members are larger (higher) than the length S of a flange 9 of the end protective member 6.例文帳に追加

突状材はテーパー形状で、突状材の高さＨは端部保護材６のフランジ９の長さＳよりも長い(高い)。 - 特許庁

A tail section 11 is formed to a length, projecting slightly from the tip section of a capillary 6.例文帳に追加

テール部１１をキャピラリ６の先端部より僅かに突出した長さに形成する。 - 特許庁

The projecting part 30 is formed into an elongated shape along the longitudinal direction of the shape of an opening of the guiding hole 21 so as to include the length L2 of the opening form by the length L1 of the projecting part 30.例文帳に追加

また、この突出部３０は、その長さＬ１が案内孔２１の開口形状の長さＬ２を含むように、当該開口形状の長手方向に沿って細長く形成される。 - 特許庁