parallel weldingとは 意味・読み方・使い方

SYSTEM AND METHOD FOR PROVIDING PARALLEL POWER SOURCE FOR ARC CUTTING AND WELDING例文帳に追加

アーク切断および溶接のための並列電源を与えるシステム及び方法 - 特許庁

A plurality of covered wires W is extracted parallel and connected to a pressure welding connector C.例文帳に追加

複数の被覆電線Ｗを概ね平行に繰出して圧接コネクタＣと接続する。 - 特許庁

A plurality of covered wires W is supplied in parallel and connected to a pressure welding connector C.例文帳に追加

複数の被覆電線Ｗを概ね平行に送給して圧接コネクタＣと接続する。 - 特許庁

In the gas shielded arc welding method where welding is performed while oscillating a welding torch, gas shielded arc welding is performed at a bevel angle of ≤50° while oscillating for 30 to 150 times per min in such a manner that the components parallel to the welding wire of the oscillating lie in the range of 10 to 45 mm.例文帳に追加

溶接トーチをオシレートさせながら溶接を行なうガスシールドアーク溶接方法において、オシレートの溶接線に平行な成分が10〜45mmの範囲内で毎分30〜150回オシレートさせながら開先角度50°以下のガスシールドアーク溶接を行なう。 - 特許庁

To provide a welding method of a battery container having larger welding intensity to a lead material even with low welding current and having less variations when a lead material is welded by a parallel type resistance welding method.例文帳に追加

パラレル式抵抗溶接方法でリード材を溶接したときに、低い溶接電流であってもリード材との溶接強度が大きくなり、しかもそのばらつきが小さくなる電池容器の溶接方法を提供する。 - 特許庁

The welding line (w) of the temporarily welded semicylindrical casing 10 is inverted to become substantially parallel with a surface of the surface plate F, the welding line (w) is made to face sideways, and then real welding is performed.例文帳に追加

仮り溶接された半筒状ケーシング１０の溶接ラインｗが定盤Ｆ上面と略平行になるように反転させ、溶接ラインｗを横向きにして本溶接する。 - 特許庁

To strengthen welding strengh between a lead material for battery and a battery case at the time that the lead material is welded into the case by parallel resistance welding method, and stabilize the welding strength.例文帳に追加

電池容器にパラレル式抵抗溶接法で溶接したときに両者の間の溶接強度が高くなりしかも安定化する電池用リード材とそれを用いた電池パックを提供する。 - 特許庁

A welding surface between these welded surfaces is made in parallel with the centerline of the main body member 152 and irradiation of the electron beam is applied along the straight-line crossing the welding surface.例文帳に追加

溶接面を本体部材１５２の中心線に平行とし、電子ビームをその溶接面と交差する直線に沿って照射する。 - 特許庁