電圧増倍器の英語

予め光電子増倍管にある一定の光を照射して、印加電圧に対する信号量を記憶部２１０に記憶させ、これを基に、光電子増倍管の増幅率を印加電圧と増幅器の増幅率で信号量を調整し、感度や印加電圧特性の異なる複数の光電子増倍管の信号強度をＳ／Ｎ比を悪化させることなく、感度補正を行う。例文帳に追加

A photomultiplier is irradiated beforehand with some constant light, and a signal quantity to an applied voltage is stored in a storage part 210, and the amplification factor of the photomultiplier is adjusted by the applied voltage and the amplification factor of an amplifier in terms of the signal quantity based thereon, and sensitivity correction of the signal intensity of a plurality of photomultipliers having each different sensitivity or applied voltage characteristic is performed without deteriorating the S/N ratio. - 特許庁

電源Ｖａの電圧値を信号ラインＤＬに供給されるＲＧＢ反転信号の反転中心電圧Ｖｃの２倍の値とすることによって、増幅器に供給される電圧は反転中心電圧Ｖｃに対して反転された電圧値となり、反転ＲＧＢ信号が生成される。例文帳に追加

By making the voltage value of the power source Va twice as high as the inversion center voltage Vc of the R.G.B inversion signals to be supplied to the signal line DL, the voltage to be supplied to the amplifiers is inverted against the inversion center voltage Vc, and thus inverted R.G.B signals are generated. - 特許庁

検出器電圧を低電圧から段階的に上げつつ、各電圧で二次電子増倍管からの出力信号を２値化したパルス信号の計数値を順次取得する（Ｓ１、Ｓ２）。例文帳に追加

While gradually increasing the detector voltage from a low voltage, the counted value of a pulse signal generated by binarizing an output signal from a secondary electron multiplication tube is sequentially obtained at each voltage (S1, S2). - 特許庁

表面検査装置において、個々の光学検出器８ａ〜８ｃの光電子増倍係数を計測し、計測した光電子増倍係数を基に制御部１１が補正印加電圧を計算する。例文帳に追加

In the surface inspection device, photoelectron multiplication factors of each of the optical detectors 8a-8c are measured, and a control unit 11 calculates a correction applied voltage based on the measured photoelectron multiplication factors. - 特許庁

第１の電流電圧変換回路８と同一の直流および交流回路特性を持つ第２の電流電圧変換回路９の出力を利得１倍の反転増幅器７で反転し、差動増幅器１に基準電圧として与えることによって、第１の電流電圧変換回路８において発生するオフセット電圧を小さくする。例文帳に追加

An inverting amplifier 7 with a gain of unity inverts the output of a 2nd current voltage conversion circuit 9 that has a DC and AC circuit characteristic the same as that of a 1st current voltage conversion circuit 8, and gives the inverted output to a differential amplifier 1 as a reference voltage so as to reduce an offset voltage produced in the 1st current voltage conversion circuit 8. - 特許庁

分圧器３１２ネットワークと、光電子増倍管を静電的にバイアスするために使用される高電圧供給源とが、ゲート回路構成要素にパワーを与え、ゲート電圧パルスを伝達する。例文帳に追加

A voltage divider 312 network and a high-voltage power supply used to statically bias the photomultiplier tube also power the gating circuitry and transmit a gating voltage pulse. - 特許庁

閾値電圧Ｖｔｐ，Ｖｔｍは、増幅器に入力されたアナログ音響信号のレベルがゼロのときの前記パルス幅変調信号の自励発振周波数の周期の１０倍〜５０倍の範囲内の所定時間に設定される。例文帳に追加

The threshold voltages Vtp, Vtm are set in prescribed time within the range of 10 to 50 times as large as a period of a self-exciting oscillation frequency in a pulse width modulation signal when the level of an analog acoustic signal input to the amplifier is zero. - 特許庁

そして、発光モニタ用光検出器（ＰＤ）９の出力Ｖｏと測距用光検出器（ＡＰＤ）４の出力Ｖｘとの比（増倍率）Ｍｘを求め、前記比（増倍率）Ｍｘが目標値Ｍに近づくように、測距用光検出器（ＡＰＤ）４のバイアス電圧を補正する。例文帳に追加

The optical range finder obtains a ratio (multiplication) Mx of an output Vo of the photodetector for the light emission monitor (PD) 9 to an output Vx of the ranging photodetector (APD) 4 and corrects a bias voltage of the ranging photodetector (APD) 4 so that the ratio (multiplication) Mx is near to a target value M. - 特許庁