| 例文 |
data strobeの部分一致の例文一覧と使い方
該当件数 : 412件
Then the light is transmitted to the free space, a demultiplexer reception section 111 demultiplexes the received signal, a photoelectric conversion section 112 decodes the signal into the data signal and the strobe so as to facilitate clock recovery.例文帳に追加
IEEE1394のデータ信号とストローブ信号とを、それぞれ発光素子104により光信号に変換し、偏向部105により直交偏向し、レンズ106により多重化し、空間に送出し、分離受信部111により分離し、光/電気変換部112によりデータ信号とストローブ信号に復号し、クロック再生を容易化する。 - 特許庁
By a delay (a'+b'+c'+d' or e') given to the feedback clock signal by an input buffer 112 and a DLL delay circuit 113 installed in a feedback path, a delay (a+b+c+d or e) given to a data strobe signal DSQ inputted to the memory control LSI 1 is compensated.例文帳に追加
引き戻し経路に配設された入力バッファ112およびDLL遅延回路113によって引き戻しクロック信号に与えられる遅延(a’+b’+c’+d’またはe’)により、メモリ制御LSI1に入力されるデータストローブ信号DQSに与えられる遅延(a+b+c+dまたはe)が補償される。 - 特許庁
The data bus communication system is configured to transmit or receive information signals from an information processing device 1 of a host side to a desired information processing device 2 of a client side at desired transfer timing only by connecting at least one read/write selection signal line 3, one data strobe signal line 4, and one acknowledge signal line 5 for one information processing device 2 at the client side.例文帳に追加
このデータバス通信システムでは、一つのクライアント側の情報処理装置2当りに、最低限、1本のリードライト選択信号線3と、1本のデータストローブ信号線4と、1本のアクノリッジ信号線5とを接続するだけで、ホスト側の情報処理装置1から所望のクライアント側の情報処理装置2に対して、所望の転送タイミングで情報信号の送信や受信を行うことが可能に設定されている。 - 特許庁
This data bus communication system is set up so that transmission and reception of an information signal from an information processor 1 of a host side to a desired information processor 2 of a client side can be performed at desired transfer timing only by connecting at least one read/write selection signal line 3, one data strobe signal line 4, and one acknowledge signal line 5 for one information processor 2 at the client side.例文帳に追加
このデータバス通信システムでは、一つのクライアント側の情報処理装置2当りに、最低限、1本のリードライト選択信号線3と、1本のデータストローブ信号線4と、1本のアクノリッジ信号線5とを接続するだけで、ホスト側の情報処理装置1から所望のクライアント側の情報処理装置2に対して、所望の転送タイミングで情報信号の送信や受信を行うことが可能に設定されている。 - 特許庁
The display driver starts downloading a display control command in response to the strobe signal change, and controls the display designated by mode information acquired from the display control command to the display element designated by element designation information acquired from the display control command with using requisite driving data when address information designates the address for the display driver itself.例文帳に追加
表示ドライバは、ストローブ信号の変化に応じて表示制御コマンドの取り込みを開始し、アドレス情報が自らのアドレスを指定しているとき、当該表示制御コマンドから取得した素子指定情報で指定された表示素子に対し、必要な駆動データを用いて、当該表示制御コマンドから取得したモード情報で指定された表示制御を行う。 - 特許庁
A CPU 7 of the camera main body calculates a correction coefficient on the basis of focal distance information of an imaging lens 1, object range information and the data with respect to the light distribution characteristics of the strobe 101, and an ASIC (Application Specific IC) 5 uses the correction coefficient to apply luminance correction to the photographed image thereby correcting the surrounding luminous quantity of the photographed image.例文帳に追加
カメラ本体のCPU7では、撮影レンズ1の焦点距離情報、物体距離情報とストロボ101の配光特性に関するデータとに基づいて補正係数を演算して算出し、ASIC5で当該補正係数を用いて撮影画像に対する輝度補正を行うことにより、撮影画像の周辺光量の補正を行う。 - 特許庁
An image output timing generator 10 multiplexes a horizontal synchronizing signal 1a, a vertical synchronizing signal 1b, a set strobe signal 3a, a set clock signal 3b, and a set data signal 3c to gather these signals as one composite signal 10a, and outputs the composite signal 10a and an image clock signal 1c to a drive timing generator 20.例文帳に追加
映像出力タイミング発生器10は、水平同期信号1a、垂直同期信号1b、設定ストローブ信号3a、設定クロック信号3bおよび設定データ信号3cを多重し、複合信号10aとして一つの信号に纏め、複合信号10aと映像クロック信号1cを駆動タイミング発生器20へ出力する。 - 特許庁
When a controller 15 detects that battery voltage drops down below V2, the controller sets this camera device in a low power consumption mode by interrupting a signal reading operation by an imaging part 13 from a CCD 12, a driving operation of an image lens 11 by an AF lens driving part 18, a charging operation of a strobe 17, or the like and then preferentially performs only recording processing of image data.例文帳に追加
電池電圧がV2以下に低下したことを検出すると、コントローラ15は撮像部13によるCCD12からの信号読み出し動作、AFレンズ駆動部18による撮影レンズ11の駆動動作、ストロボ17の充電動作などを中断することにより本カメラ装置を低消費電力モードに設定した上で、画像データの記録処理のみを優先して行う。 - 特許庁
The mask control circuit further generates a mask signal for delay calculation prohibiting the detection by the delay calculation circuit except in a non-mask period including only a part of an active state a predetermined time after READ command transmission, and generates the read mask signal according to the delay of the data strobe signal calculated by the delay calculation circuit via the mask signal for delay calculation.例文帳に追加
マスクコントロール回路は、さらに、READコマンド送信から所定の時間の後から活性状態の一部のみを含む非マスク期間を除いて、遅延値計算回路による検出を禁止する遅延値計算用マスク信号を生成し、遅延値計算用マスク信号を利用して遅延値計算回路により計算されたデータストローブ信号の遅延値に基づいて、読み取りマスク信号を生成する。 - 特許庁
The support apparatus can be automated through the use of one or more mobile strobe lights 302 slidably coupled to each leg, capable of self-propelled linear motion along the axis of the leg and providing indication of its position along the leg to facilitate acquisition of multiple photographic images and position data for the image processing operations.例文帳に追加
この支持装置は、各脚部に摺動自在に結合されかつ脚部の軸線に沿って自走式の直線運動をすることができる1つまたは複数の移動ストロボ302であって、脚部に沿って位置を指し示し、画像処理操作のための、複数の写真画像および位置データの収集を容易ならしめる移動ストロボ302の使用を通して自動化することができる。 - 特許庁
In a transmission side transmitting/receiving unit 14, a driving/ processing circuit 20 controls driving of light emitting elements 22A and 22B depending on two related electric signals (Data signal, Strobe signal) inputted from an external unit to produce optical signals of different wavelength which are then guided by beam splitters 26A and 26B to a wavelength filter 28 where they are synthesized before entering an optical fiber 12.例文帳に追加
送信側の送受信ユニット14では、駆動・処理回路20によって、外部装置から入力された関連する2つの電気信号(Data信号、Strobe信号)に応じて、発光素子22A、22Bの駆動を制御することによって互いに異なる波長の光信号に各々変換し、ビームスプリッタ26A、26Bにより波長フィルタ28に案内し、波長フィルタ28で合成して光ファイバ12に入射する。 - 特許庁
A timing for rising and falling of a reference clock outputted simultaneously with data read from a semiconductor device is read by plural signal reading circuit sampling acting with strobe pulse consisting of polyphase pulse having slight phase difference, and the timing for rising and falling of the reference clock is prescribed by a phase number of the polyphase pulse detecting a changing point, and the phase number is memorized by a memory 32.例文帳に追加
被試験半導体デバイスから読み出されるデータと共に出力される基準クロックの立上り又は立下りのタイミングをわずかずつ位相差が与えられた多相パルスで構成されたストローブパルスでサンプリング動作する複数の信号読取回路で読み取り、その変化点を検出した多相パルスの相番号により基準クロックの立上り又は立下りのタイミングを規定すると共に、この相番号をメモリ32に記憶する。 - 特許庁
| 例文 |
| Copyright © Japan Patent office. All Rights Reserved. |
|
ログイン |
Weblio会員(無料)になると
|
|
ログイン |
Weblio会員(無料)になると
|