意味 | 例文 (142件) |
下口節の英語
追加できません
(登録数上限)
「下口節」の部分一致の例文検索結果
該当件数 : 142件
流入口4側の圧力が高圧の場合には、降下位置調節部材13を下げてフロート12の降下位置を下方に調節し、流入口4側の圧力が低圧の場合には、降下位置調節部材13を上げてフロート12の降下位置を上方に調節する。例文帳に追加
When pressure on the side of the inflow port 4 is high, the lowering position adjusting member 13 is lowered to adjust the lowering position of the float 12 to the lower side, and when the pressure on the side of the inflow port 4 is low, the lowering position adjusting member 13 is raised to adjust the lowering position of the float 12 to the upper side. - 特許庁
ガスの吹出口33は、開口端面に調節板34を取り付け、調節板34をそれぞれ上下、左右にスライドして風量と風向を変化させる。例文帳に追加
The gas blowout ports 33 have adjustment plates 34 fitted to the opening end face, which slide to the upper and lower, and the right and left to change a wind volume and a wind direction. - 特許庁
少なくとも3つの節部を有する竹筒の、最上部の節部に差し口を形成し、その反対側の筒部に注入口を形成し、中間部の節部に通水孔及び通気孔を形成し、最下部の節部を底部とする。例文帳に追加
The spigot is formed at an uppermost node of a bamboo stalk having at least three nodes, a pouring-in port is formed at the stalk on a position at the opposite side, a water hole and an air hole are formed at the middle node, and the lowermost node is made to serve as a bottom. - 特許庁
ここでガイド棒4の途中に漏斗本体1の排出口2を開閉する調節駒18を上下動調節可能に嵌合させてもよい。例文帳に追加
An upward downward adjustable adjusting piece 18 may be mated with the middle of the guide bar 4 to open and close the discharge aperture 2 of the funnel main body 1. - 特許庁
プレート体31の下部には弾力調節プレート40の下部係合部55が係合する下部開口部60を形成する。例文帳に追加
A lower opening portion 60 for engagement with the lower engagement portion 55 of the elasticity adjusting plate 40 is formed on the lower portion of the plate body 31. - 特許庁
また、水溜トラップの一端開口を排水桝23内に上方を向けて開口させ、該開口に鉛直方向の水位調節パイプ25を着脱可能に装着して地下水位の調節と排水とを行う。例文帳に追加
One opening of the pool trap is opened upward in the drainage pit 23, and a water level-regulating pipe 25 in the vertical direction is detachably attached to the opening to regulate the underground water level and to drain the water. - 特許庁
-
履歴機能過去に調べた
単語を確認! -
語彙力診断診断回数が
増える! -
マイ単語帳便利な
学習機能付き! -
マイ例文帳文章で
単語を理解!
「下口節」の部分一致の例文検索結果
該当件数 : 142件
差圧調節手段11の弁体22の開口面積をステッピングモーター23と制御手段14で調節可能とし、差圧調節手段11の上流と下流間の差圧が一定となるようにその開口面積を調節している。例文帳に追加
The area of an opening of the valve body 22 of a differential pressure regulating means 11 is regulatable by a stepping motor 23 and a control means 14, and the area of the opening is regulated so that the differential pressure between the upstream part and the downstream part of the regulating means 11 becomes constant. - 特許庁
前記第1及び第2導出入口はスリット状であり、その上下方向の開口寸法が調節可能とされている。例文帳に追加
The first and second introduction and extraction openings are formed into a slit-like shapes, and an opening dimension in the vertical direction thereof is made adjustable. - 特許庁
出口ヘッダ10の上部に出口側圧力センサ4を取り付け、下方に自動調節弁5を接続する。例文帳に追加
An outlets side pressure sensor is attached to an upper part of an outlet header 10, and a control valve 5 is connected below it. - 特許庁
弁体の連通孔を通して入口から出口へ流下する流量を調節することができるばね付勢逆止弁を提供する。例文帳に追加
To provide a spring energized check valve adjusting a flow rate flowing down to an outlet from an inlet through the communication hole of a valve element. - 特許庁
案内体3の下端部内側には開口部2の閉鎖時に磁性体16に吸着する磁石体を上下方向に移動調節可能に設ける。例文帳に追加
A magnet body attracted to the magnetic body 16 when closing the opening 2 is provided in a vertically movable and adjustable manner inside the lower end part of the guide body 3. - 特許庁
流入口4側の圧力が高圧の場合には、フロート受け10の位置を下方に調節し、流入口4側の圧力が低圧の場合には、フロート受け10の位置を上方に調節する。例文帳に追加
If flow-in port 4 side pressure in high, position of the float receiver 10 is adjusted to a lower position and if flow-in port 4 side pressure is low, position of the float receiver 10 is adjusted to a higher position. - 特許庁
また、羽口を炭化室の直上に設けた下段羽口4bと、燃焼室の上部に設けた上段羽口4aとの二段羽口とし、それぞれに空気吹込み量を調節できるようにする。例文帳に追加
The furnace is equipped with two stage tuyeres composed of a bottom tuyere 4b disposed at overhead of the carbonization chamber and a top tuyere 4a disposed at the top of the combustion chamber, and the blow rate of air to the each tuyere is adjustable. - 特許庁
導入口と排出口を表面に備え、導入口と排出口とをつなげる流体用通路を内部に備え、切削チップ2のすくい面に接して温度調節する切削チップ温度調節器1を取り付けて、切削チップ温度調節器に冷却液を供給すると、切削液を供給せずに切削チップの刃先温度を低下させる。例文帳に追加
When cooling fluid is supplied to the cutting tip thermoregulator 1, a cutting edge temperature of the cutting tip 2 is lowered without supplying the cutting fluid. - 特許庁
|
意味 | 例文 (142件) |
ピン留めアイコンをクリックすると単語とその意味を画面の右側に残しておくことができます。 |
ログイン |
Weblio会員(無料)になると 検索履歴を保存できる! 語彙力診断の実施回数増加! |
weblioのその他のサービス
ログイン |
Weblio会員(無料)になると 検索履歴を保存できる! 語彙力診断の実施回数増加! |