小窓モード


プレミアム

ログイン
設定

設定

Weblio 辞書 > 英和辞典・和英辞典 > 機械工学英和和英辞典 > constant load testの意味・解説 

constant load testとは 意味・読み方・使い方

ピン留め

追加できません

(登録数上限)

単語を追加

機械工学英和和英辞典での「constant load test」の意味

constant load test


「constant load test」の部分一致の例文検索結果

該当件数 : 14



例文

The constant load tensile test is a test applying 9.8N constant load to the length direction of a test piece having 20mm width for 24 hours under a 23°C-50% RH condition.例文帳に追加

定荷重引張試験:23℃−50%RHの条件下で20mm幅の試験片の長さ方向に9.8Nの定荷重を24時間付加 - 特許庁

To provide a power steering characteristic test method for automobile and apparatus thereof that performs a characteristic test by providing a constant load with no pulsation and vibration to an output shaft.例文帳に追加

脈動や振動等の変動のない一定負荷を出力軸に与えて特性試験する自動車用パワーステアリングの特性試験方法及び装置を提供する。 - 特許庁

The drive IC includes a reference voltage setting circuit for outputting reference voltage by test voltage, and a load current control section for comparing load voltage output from load resistance with the reference voltage in response to load current flowing in load and maintaining the load current at a constant level on the basis of comparison results.例文帳に追加

本発明の駆動ICは、テスト電圧によって基準電圧を出力する基準電圧設定回路と、負荷に流れる負荷電流に応答して負荷抵抗から出力される負荷電圧と基準電圧とを比較し、該比較結果に基づいて負荷電流を一定に維持させる負荷電流制御部と、を含む。 - 特許庁

During the interruption of the test, an internal target signal producing circuit 5b is controlled and a switch 55 is opened so that the target value is constant but load is applied to the testpiece.例文帳に追加

試験中断中はその目標値一定で供試体が負荷されるように内部目標信号発生回路5bを制御するとともにスイッチ55を開放する。 - 特許庁

To identify the motor constant and load torque of a permanent magnet type synchronous motor without using a current detector for detecting a current flowing through a motor for driving a permanent magnet type synchronous motor under test (synchronous motor for test) or a synchronous motor under test.例文帳に追加

試供永久磁石型同期電動機(テスト用の同期電動機)を駆動するための駆動用電動機や、試供同期電動機に流れる電流を検出する電流検出器を用いることなく、永久磁石型同期電動機の電動機定数及び負荷トルクの同定を行う。 - 特許庁

This test system is provide with a screw roller 1, which uses rolling to form a screw section B1 on top of the machine bolt B, and a proof loading mechanism 8 which pulls up the head B2 of the machine bolt B, to apply a constant proof load between the head B2 and the screw section B1, and determines whether it passes the proof load test.例文帳に追加

頭付ボルトBの先端部にローリング転造でネジ部B1を形成するネジ転造装置1の転造終了位置に、頭付ボルトBの頭部B2を引き上げて頭部B2とネジ部B1との間に一定の保障荷重を負荷し、保障荷重試験に合格するか否かを測定する保障荷重負荷機構8を備えた。 - 特許庁

例文

To keep a swing of an output signal constant by automatically changing an oscillator core current in adjusting a load capacity in order to adjust an output frequency in a production test step.例文帳に追加

製造試験段階で出力周波数を調節するために、負荷容量を調節する際に、発振器コア電流を自動的に変化することによって出力信号のスイングを一定に維持する。 - 特許庁

>>例文の一覧を見る

調べた例文を記録して、 効率よく覚えましょう
Weblio会員登録無料で登録できます!
  • 履歴機能
    履歴機能
    過去に調べた
    単語を確認!
  • 語彙力診断
    語彙力診断
    診断回数が
    増える!
  • マイ単語帳
    マイ単語帳
    便利な
    学習機能付き!
  • マイ例文帳
    マイ例文帳
    文章で
    単語を理解!
  • その他にも便利な機能が満載!
Weblio会員登録(無料)はこちらから

「constant load test」の部分一致の例文検索結果

該当件数 : 14



例文

To implement charge-discharge tests of high accuracy, the current value detected is allowed to approach to a constant current set value efficiently in a controller 31 for charge-discharge test controlling a DC power source apparatus 13 and an electronic load apparatus 14 for implementing charge-discharge test for an object to be tested.例文帳に追加

被試験物の充放電試験を行うために、直流電源装置13および電子負荷装置14を制御する充放電試験用コントローラ31において、効率よく定電流設定値に近づけ、高精度の充放電試験を実施する。 - 特許庁

When a power steering characteristic test method for an automobile is performed, a load L is produced by pressing to an output shaft 3 with air pressure through a pressure sensor 13, and pressing force of the air pressure is normally controlled in response to an output of the pressure sensor 13, and then a constant load L is produced at all times.例文帳に追加

自動車用パワーステアリングの特性試験をする際、出力軸3を圧力センサ13を介して空気圧で押圧することにより負荷Lを発生させ、圧力センサ13出力に応じて空気圧の押圧力を制御して常に一定の負荷Lを発生させる。 - 特許庁

The compression load F applied to the material test piece 1 is increased by the compression actuator 9 and the pressure in the chamber 2 is lowered as an increase in this compression load and the vertical stress σn applied to the shearing surface (b) of the material piece 1 vertically is made kept almost constant.例文帳に追加

そして、圧縮用アクチュエータで前記材料試験片に加わる圧縮荷重(F)を増大させるとともに、この圧縮荷重の増大にともなって、チャンバー内の圧力を低下させ、材料試験片の剪断面(b)に垂直に加わる垂直応力(σn)を略一定に維持している。 - 特許庁

The test method includes a step for driving no-load equipment by the main motor means for acting a constant torque C, a step for driving the brake system and the starter system simultaneously, and a step for recording a speed range curve Vtest.例文帳に追加

試験方法は一定トルクCを作用させる主モータ手段により負荷のない設備を駆動する工程と、ブレーキシステム及び起動システムを同時に駆動する工程と、速度範囲曲線Vtestを記録する工程とを含む。 - 特許庁

A thermoplastic resin film having a ratio (B)/(A)≥0.6 when assuming that tensile strength based on JIS K 7127 before and after a constant load tensile test defined as follows is (A) and (B), respectively, and having a haze value5% is used as the polarizer protection film.例文帳に追加

下記の定義による定荷重引張試験の前後におけるJIS K 7127に基づく引張強さをそれぞれ(A),(B)としたとき、比(B)/(A)が0.6以上であり、かつ、ヘイズ値が5%以下の熱可塑性樹脂フィルムを偏光子保護フィルムとして用いる。 - 特許庁

To provide a dielectric porcelain which has high dielectric constant, satisfies X7R characteristics of EIA standard in the temperature change of the specific dielectric constant, and in which a higher insulation resistance can be obtained even when a lower voltage is applied, and to provide a multilayer ceramic capacitor which has such dielectric porcelain as a dielectric layer and has excellent life characteristics under a high-temperature load test.例文帳に追加

高誘電率で比誘電率の温度変化がEIA規格のX7R特性を満足し、印加する電圧が低い場合にも高い絶縁抵抗が得られる誘電体磁器と、このような誘電体磁器を誘電体層として備え、高温負荷試験での寿命特性に優れる積層セラミックコンデンサを提供する。 - 特許庁

例文

This perpendicular tension type adhesion strength test machine for perpendicularly fixing the stud to the surface of the sample and performing a perpendicular tensile test has a cylindrical collet that receives the stud 1 that is arranged perpendicularly to a sample fixing position of a sample fixing plate 11 and perpendicularly fixed to the surface of the sample 10, clamps it with a constant load, and applies stress perpendicular to the sample 10 to the stud 1.例文帳に追加

試料の表面に垂直にスタッドを固定して垂直引張試験を行う垂直引張型密着強度試験機に於いて、試料固定板11の試料固定位置に垂直に配置されて試料10の表面に垂直に固定したスタッド1を受容すると共に一定加重でクランプし且つスタッド1に対し試料10と垂直な方向の応力を加える筒状のコレットを備える。 - 特許庁

>>例文の一覧を見る


constant load testのページの著作権
英和・和英辞典 情報提供元は 参加元一覧 にて確認できます。

   
日外アソシエーツ株式会社日外アソシエーツ株式会社
Copyright (C) 1994- Nichigai Associates, Inc., All rights reserved.

ピン留めアイコンをクリックすると単語とその意味を画面の右側に残しておくことができます。

こんにちは ゲスト さん

ログイン

Weblio会員(無料)になると

会員登録のメリット検索履歴を保存できる!

会員登録のメリット語彙力診断の実施回数増加!

無料会員に登録する

このモジュールを今後表示しない
みんなの検索ランキング
閲覧履歴
無料会員登録をすると、
単語の閲覧履歴を
確認できます。
無料会員に登録する
英→日 日→英
こんにちは ゲスト さん

ログイン

Weblio会員(無料)になると

会員登録のメリット検索履歴を保存できる!

会員登録のメリット語彙力診断の実施回数増加!

無料会員に登録する

©2026 GRAS Group, Inc.RSS