1016万例文収録!

「block-level element」に関連した英語例文の一覧と使い方 - Weblio英語例文検索


小窓モード

プレミアム

ログイン
設定

設定

Weblio 辞書 > 英和辞典・和英辞典 > block-level elementの意味・解説 > block-level elementに関連した英語例文

セーフサーチ:オン

不適切な検索結果を除外する

不適切な検索結果を除外しない

セーフサーチについて

block-level elementの部分一致の例文一覧と使い方

該当件数 : 12



例文

When the output signal of the heater temperature control block 16 turns to a low level, the switch element 5 is turned off, so that charging to the inductor 4 is stopped.例文帳に追加

ヒータ温度制御ブロック16の出力信号がローレベルになると、スイッチ素子5がオフされインダクタ4への充電は停止する。 - 特許庁

When the output signal of a heater temperature control block 16 reaches a high level, a switch element 5 is turned on, so that an inductor 4 is charged with energy.例文帳に追加

ヒータ温度制御ブロック16の出力信号がハイレベルになると、スイッチ素子5がオンされインダクタ4にエネルギーが充電される。 - 特許庁

To provide a three-level power conversion device that prevents a switching element from being brought into an overvoltage state, even if the operation of a gate block becomes unstable.例文帳に追加

ゲートブロックの動作が不安定となっても、スイッチング素子が過電圧とならない3レベル電力変換装置を提供する。 - 特許庁

When record data incoming signals to the recording element substrate are all bits High level signals or all bits Low level signals, the block selection signal of a time sharing drive is considered as an empty block selection signal for which the corresponding heating resistive element does not exist.例文帳に追加

記録素子基板への記録データ入力信号が全ビットHighレベル信号、もしくは全ビットLowレベル信号であった場合、時分割駆動のブロック選択信号を、対応する発熱抵抗素子がない空ブロック選択信号とする。 - 特許庁

例文

This melt spinning assembly has such a scheme that when polymer pressure comes to a specified level, a polymer is issued from at least one element among a pump block 2, a distribution block 5 and a metal gasket 12 sandwiched by the pump block 2 and the distribution block 5.例文帳に追加

ポリマー圧力が所定の圧力になると、ポンプブロック2、分配ブロック5と、該ポンプブロック2と該分配ブロック5に挟着されたメタルガスケット12の内の少なくとも1個所からポリマーが流出するように構成してある。 - 特許庁


例文

The on-block circuit 56 detects the voltage between main electrodes of the synchronously rectifying element 31, and blocks the conduction of the synchronously rectifying element 31, until the detected voltage is a prescribed level or smaller.例文帳に追加

オン阻止回路56は同期整流素子31の主電極間の電圧を検出し、検出電圧が所定値以下になるまで同期整流素子31の導通を阻止する。 - 特許庁

The block element 20 prevents the adhesion element 30 from overflowing into the conductive connection element on the active surface of the chip and then contaminating it during the adhesion of the chip, and also lowers the level of the adhesion element 30 so as to reduce a probability that particles (EMC filler) damage the active surface of the chip 40.例文帳に追加

ブロック素子20はチップ粘着時に、粘着素子30がチップのアクティブ表面上の導電連接点に溢出して汚染するのを防止し、粘着素子30の高度を制限して、粒子(EMCフィラー)がチップ40のアクティブ表面を傷つける確率を低下させる。 - 特許庁

In an initial inspection, defect detection processing for the solid- state image pickup element is performed, a defect number is attached to the detected defective pixel, and defect information (a defective part and a defective level) is successively stored in a memory space block 10.例文帳に追加

初期検査時において、固体撮像素子の欠陥検出処理を行い、この検出された欠陥画素に欠陥番号を付して欠陥情報(欠陥個所、欠陥レベル)を順次メモリ空間ブロック10に格納していく。 - 特許庁

To provide a surface acoustic wave (SAW) device in which a SAW element is electromagnetically shielded, an attenuation quantity in a block zone on the high frequency side of a passband has a sufficient level, undesired short-circuiting or the like does not occur and the SAW element is packaged by a face-down system.例文帳に追加

弾性表面波素子が電磁シールドされ、通過帯域高域側の阻止域における減衰量が十分な大きさとされており、所望でない短絡等が生じ難い、弾性表面波素子がフェースダウン方式でパッケージ化されている弾性表面波装置を提供する。 - 特許庁

例文

To prevent noise from being propagated to another circuit block in the same buffer element by separating a buffer for clock signals and to suppress an image noise and an EMI radiation level within allowable ranges by setting an optimal diffusion degree corresponding to the conditions of buffer elements in each of circuit blocks.例文帳に追加

クロック信号のバッファを分別することにより、同一バッファ素子内で他の回路ブロックにノイズが伝播するのを防止し、かつ各回路ブロックのバッファ素子の条件に応じて最適な拡散度に設定することにより、画像ノイズとEMI放射レベルを許容範囲内に抑えること。 - 特許庁

例文

In a high side switch circuit having the switching element at a high level side of a load in the semiconductor integrated circuit device adopting a separation structure for a rear side power supply voltage, a diode D1 is inserted to a current path from a ground terminal GND to an output terminal OUT in the opposite polarity to block the current path when a negative voltage is applied to the output terminal OUT as a feature.例文帳に追加

裏面電源電圧の分離構造を用いた半導体集積回路装置であって、負荷の高電位側にスイッチング素子を有するハイサイドスイッチ回路において、接地端子GNDから出力端子OUTに抜ける電流経路に、ダイオードD1を逆方向に挿入し、出力端子OUTに負電圧が印加された場合に上記電流経路をブロックすること特徴としている。 - 特許庁

例文

The light emitting element 100 includes a first electrode 140, a second electrode 150 disposed apart from the first electrode 140, a light emission pattern 114 including a part between the first electrode 140 and second electrode 150, and a block pattern 120 including a part at least either between the light emission pattern 114 and first electrode 140 or in level with the first electrode 140.例文帳に追加

発光素子100は、第1電極140と、第1電極140から離隔されて位置する第2電極150と、第1電極140と第2電極150との間にある部分とを含む発光パターン114、および発光パターン114と第1電極140の間および第1電極140と同一のレベル上の少なくとも一方にある部分を含むブロックパターン120を含む。 - 特許庁

索引トップ用語の索引



  
Copyright © Japan Patent office. All Rights Reserved.
こんにちは ゲスト さん

ログイン

Weblio会員(無料)になると

会員登録のメリット検索履歴を保存できる!

会員登録のメリット語彙力診断の実施回数増加!

無料会員に登録する
英→日 日→英
こんにちは ゲスト さん

ログイン

Weblio会員(無料)になると

会員登録のメリット検索履歴を保存できる!

会員登録のメリット語彙力診断の実施回数増加!

無料会員に登録する

©2024 GRAS Group, Inc.RSS