| 例文 |
charge overcurrentの部分一致の例文一覧と使い方
該当件数 : 27件
To provide a charge pump circuit which is capable of preventing overcurrent during operation.例文帳に追加
動作中の過電流を防止可能なチャージポンプ回路を提供する。 - 特許庁
Overdischarge and overcharge are detected by an overdischarge detection circuit 13 and an overcharge detection circuit 14, a discharge overcurrent and a charge overcurrent are detected by a discharge overcurrent detection circuit 15 and a charge overcurrent detection circuit 16.例文帳に追加
過放電検出回路13及び過充電検出回路14により過放電及び過充電を検出し、放電過電流検出回路15及び充電過電流検出回路16により放電過電流及び充電過電流を検出する。 - 特許庁
In the charge/discharge control circuit and the battery device, the charge overcurrent detection in an overcharged state and the discharge overcurrent detection in an overdischarged state are invalidated.例文帳に追加
充放電制御回路及びバッテリ装置において、過充電状態での充電過電流検出と過放電状態での放電過電流検出を無効とする構成とした。 - 特許庁
VOLTAGE DETECTING CIRCUIT, OVERCURRENT DETECTING CIRCUIT, CHARGE CURRENT CONTROL SYSTEM, AND VOLTAGE DETECTING METHOD例文帳に追加
電圧検出回路、過電流検出回路、充電電流制御システム、及び電圧検出方法 - 特許庁
Therefore, it is possible to detect charge overcurrent in the state of overdischarge protection and discharge overcurrent in the state of overdischarge protection.例文帳に追加
これにより、過放電保護状態における充電過電流の検出や、過充電保護状態における放電過電流の検出を可能とする。 - 特許庁
To suppress an overcurrent of a charge pump circuit without deteriorating step-up efficiency (or step-down efficiency).例文帳に追加
昇圧効率(または降圧効率)を低下させることなくチャージポンプ回路の過電流を抑制する。 - 特許庁
On the other hand, when the count time is under the delay time, it determines whether or not the charge/discharge current is the overcurrent detecting current or over, and when the charge/discharge current is under the overcurrent detecting current, it finishes time count.例文帳に追加
一方、カウントされた時間が遅延時間未満の場合には、充放電電流が過電流検出電流以上であるか否かを判断し、充放電電流が過電流検出電流未満である場合には、時間の計測を終了する。 - 特許庁
This battery pack determines whether a charge/discharge current flowing in a current detecting resistor 14 is an overcurrent detecting current or over.例文帳に追加
電流検出抵抗14に流れる充放電電流が過電流検出電流以上であるか否かを判断する。 - 特許庁
A detection signal of the overcurrent detection circuit is input to a communication terminal of an over-discharge signal of the battery state monitoring circuit on a side where the overcurrent detection circuit is installed and to a communication terminal of an over-charge signal.例文帳に追加
過電流検出回路の検出信号を、過電流検出回路が設けられた側のバッテリ状態監視回路の過放電信号の通信端子と過充電信号の通信端子とに入力する。 - 特許庁
The discharge overcurrent detection circuit 15 and the charge overcurrent detection circuit 16 detect the direction of a current flowing through the secondary battery 10, and a discharge control circuit 11 and a charge control circuit 12 control a part of the discharge FETQ11, Q12 and the charge FETQ21, Q22 to be off based on the detection results.例文帳に追加
放電過電流検出回路15及び充電過電流検出回路16は、二次電池10に流れる電流方向を検出し、それらの検出結果に基づいて放電制御回路11及び充電制御回路12により放電FETQ11,Q12及び充電FETQ21,Q22の一部をオフに制御する。 - 特許庁
The charge/discharge control circuit is constituted so as to switch a logic circuit of a charge inhibition signal and a discharge inhibition signal and an overcurrent detection circuit by using a voltage of a signal inputted into a terminal by installing the input terminal.例文帳に追加
入力端子を設けて、端子に入力される信号の電圧によって、充電禁止信号および放電禁止信号の論理と過電流検出回路の回路を切り替える構成とした。 - 特許庁
To provide a discharge and charge control circuit, capable of determining the detection current value of an overcurrent detection circuit, and to provide a rechargeable power supply unit.例文帳に追加
過電流検出回路の検出電流の値を精度よく設定することが可能な充放電制御回路および充電式電源装置の提供。 - 特許庁
To obtain a charge pump system DC-DC converter which is equipped, at its prestage, with a voltage stabilization circuit which has a protection circuit against overcurrent, capable of making the current outputted from a charge pump circuit part drop to a desired current value, even when the output terminal of the charge pump circuit part is short-circuited to ground voltage.例文帳に追加
チャージポンプ回路部の出力端子が接地電圧に短絡した場合でも、チャージポンプ回路部から出力される電流を所望の電流値まで低下させることができる過電流保護回路を有する、前段に定電圧回路を備えたチャージポンプ式のDC−DCコンバータを得る。 - 特許庁
To provide a handy charge/discharge protective circuit which is of low current consumption in the detection state of an overcurrent and is easy of computing automatic recovery impedance.例文帳に追加
過電流検出状態において低消費電流であり、かつ自動復帰インピーダンスが計算しやすい、使い勝手の良い充放電保護回路を提供すること。 - 特許庁
The overcurrent protection circuit is provided at least with a driver control circuit 6, a fault detection circuit 7, a protection circuit, a charge injection circuit 31 and a power supply 9.例文帳に追加
過電流保護回路は、駆動制御回路6と、異常検出回路7と、保護回路8と、電荷注入回路31と、電源9とを少なくとも備えている。 - 特許庁
Meanwhile, in an overcurrent state, the output of the hysteresis comparator 51 is at a high level, the n type MOS transistor 63 is turned on, and the electric charge of the capacitor 62 is discharged.例文帳に追加
一方過電流状態では、ヒステリシスコンパレータ51出力がハイレベル、n型MOSトランジスタ63がオン状態となり、キャパシタ62の電荷は放電される。 - 特許庁
To provide a charge/discharge protection circuit and a battery pack wherein lower overcurrent detection level and high precision can be concurrently achieved inexpensively and by a simple configuration.例文帳に追加
安価に且つ簡易な回路構成により、過電流検出レベルの低下と、高精度化とを両立することができる充放電保護回路および電池パックを提供する。 - 特許庁
As the same voltage value is determined according to a difference between a present charge state and a full-charge state, charging by an overcurrent and charging exceeding the capability can be avoided, so that stable charging can be practiced.例文帳に追加
また、この同一の電圧値は、現在の充電状態と、満充電との差に基づいて決定されるため、過電流による充電や、能力以上の充電がなされることはなく、安定した充電を行うことができる。 - 特許庁
When the secondary battery is judged to be in overcurrent state based on the magnitude of the charge/discharge current thereof, an overcurrent detecting circuit 20 controls the discharge current interrupting means to bring about an interrupted state preferentially to control by the microcomputer 30.例文帳に追加
また、過電流検出回路20は、二次電池の充放電電流の大きさに基づいて、二次電池が過電流状態であると判別した場合に、マイコン30による制御より優先的に放電電流遮断手段を遮断状態となるように制御する。 - 特許庁
To provide a safe battery device by solving the problem wherein normal operations of a charge/discharge control circuit and a battery device are hindered due to the repetition of a quasi-overcurrent phenomenon, when executing pulse charging in an overcharged state or in an overdischarged state, in the charge/discharge control circuit and the battery device.例文帳に追加
充放電制御回路及びバッテリ装置において、過充電状態あるいは過放電状態でパルス充電を行う際に、疑似的な過電流現象の繰り返しによって、上記充放電制御回路及びバッテリ装置の正常動作を障る問題を解決し、安全なバッテリ装置を提供する。 - 特許庁
To miniaturize a battery pack and the whole product, reduce the cost, and shorten the circuit designing time by introducing the functions of an over-discharge protection, overcurrent protection, and overcharge protection of a battery protecting circuit incorporated in the battery pack into a charge control circuit.例文帳に追加
電池パックに内蔵されていた電池保護回路の過放電保護、過電流保護、過充電保護の機能を充電制御回路に取り込み、電池パックの小型化、製品全体の小型化、コストの削減、回路設計時間の短縮を図る。 - 特許庁
To prevent an overcurrent more than necessary from flowing to a load circuit to break equipment parts by performing a constant current control for both of a charge current to a secondary battery built in equipment and a peak current required at quick traverse or quick return.例文帳に追加
機器に内蔵する2次電池への充電電流の定電流制御と、早送りや早戻し時に必要なピーク電流の両方を定電流制御して、負荷回路に必要以上に過大な電流が流れ機器部品が破損するのを防ぐ。 - 特許庁
To provide a charge/discharge controller that can protect a rechargeable battery cell from an overcurrent state while preventing the controller from increasing in scale or becoming complex even in a use style such that currents flowing during charging and discharging are greatly different in value.例文帳に追加
充電時と放電時に流れる電流値が大きく異なるような使用形態においても、装置規模の増大化と複雑化を防止しつつ、充放電可能なバッテリセルを過電流状態から保護することが可能な充放電制御装置を提供する。 - 特許庁
A battery state monitoring circuit is provided at least with a monitor terminal 12 for monitoring discharge current of a secondary battery and control terminals 10, 11 for controlling charge and discharge from outside, and is configured so as to maintains a fixed impedance of the monitor terminal 12 of overcurrent, when a discharge control signal is input from the outside.例文帳に追加
バッテリー状態監視回路には少なくとも、二次電池の放電電流を監視するためのモニター端子12と、外部から充電と放電の制限を行うための制御端子10,11とが設けられ、外部から放電制限信号が入力された場合には、過電流のモニター端子12のインピーダンスを一定とするような構成とした。 - 特許庁
To provide a power converter and an electric vehicle using it which rapidly discharge charge of a capacitor and prevent an electric shock when an inverter housing of the power converter is erroneously opened by a user, and also prevent damages on discharge resistors and a control circuit due to an overcurrent when a contactor is failed and welded by heat.例文帳に追加
本発明の目的は、使用者が誤って電力変換装置のインバータ筐体を開けた時、コンデンサの電荷を急速に放電し感電を防ぐことができ、又、コンタクタが熱などにより故障し溶着した時、過電流による放電抵抗と制御回路の破損を防ぐことができる電力変換装置及びそれを用いた電気車を提供することにある。 - 特許庁
| 例文 |
| Copyright © Japan Patent office. All Rights Reserved. |
|
ログイン |
Weblio会員(無料)になると
|
|
ログイン |
Weblio会員(無料)になると
|