| 例文 |
load controllerの部分一致の例文一覧と使い方
該当件数 : 1615件
The vehicle mounted system controller for controlling a specified vehicle mounted system comprises a means 3a for judging deterioration of a battery 2 based on a specified criterion by applying the voltage of a battery 2 for driving the vehicle mounted system to a specified electric load 4 connected with the battery 2 before the vehicle mounted system is driven and measuring the operating voltage of the battery 2.例文帳に追加
車両に搭載した所定の車載システムを制御する車載システム制御装置であって、車載システムを駆動するバッテリ2に接続した所定の電気的負荷4に対し、車載システムの駆動前に、バッテリ2の電圧を印加して通電することによりバッテリ2の動作電圧を測定し、所定の判定条件に基づいてバッテリ2の劣化判定を行う判定手段3aを備える。 - 特許庁
At that time, the controller 3 can correctly measure the blocking degree without being influenced by voltage fluctuation or load change of the AC 100 V by measuring a voltage produced by dividing the DC voltage by way of resistors 4 and 5 and using the measured voltage for compensating the fluctuation of measured value of the blocking degree caused by the voltage fluctuation of the AC 100 V.例文帳に追加
このとき、制御部3は、前記直流電圧を抵抗4および抵抗5で抵抗分割した電圧を測定し、前記直流電圧の変動に起因する前記閉塞度の測定値の変動を前記測定電圧により補正することにより、AC100Vの電圧変動や負荷変動に影響されずに前記閉塞度を正確に測定することができる。 - 特許庁
A punch or die mounted on a punch press 1 is made to approach by having them stroke at extremely low pressure and speed so that die damage is avoided just in case an abnormal situation happens due to being controlled by a die speed controller 43, and the pressure which affects the punch and die is detected by a load cell 18 during this stroke.例文帳に追加
パンチプレス1に装着されたパンチ金型またはダイ金型を、金型速度制御手段43の制御により万が一異常があった場合に金型等が損傷するのを回避できる程度の極めて低圧且つ極めて低速でストロークさせて接近させ、このストローク中にロードセル18によりパンチ金型またはダイ金型に作用する圧力を検出する。 - 特許庁
A signal transmission/reception processing field programmable gate array FPGA 141 applies reception processing to a state report signal from a transmitter-receiver by transferring state information to an area in a state monitor table 17 corresponding to a transmission source address in the signal so as to relieve a processing load of a control program by avoiding interruption to the control program of a monitor controller 14 at the time of reception.例文帳に追加
送受信装置からの状態報告信号について、信号送受信処理用FPGA141は、信号内の送信元アドレスに対応した状態監視テーブル17内の領域に状態情報を転送することで受信処理を行い、監視制御装置14の制御プログラムに対して受信時の割り込みを行わないことで制御プログラムの処理を軽減する。 - 特許庁
A hybrid power conditioner 100 which converts power generated by a solar battery 10 and power discharged from a storage battery 20 to AC and outputs the power to a power system 2 and a load 40 is provided with a controller 140 which sets an AC command value regarding input and output AC power of the hybrid power conditioner 100 and controls charging and discharging by the storage battery 20.例文帳に追加
太陽電池10の発電及び蓄電池20の放電により得られる電力をACに変換して電力系統2及び負荷40に対して出力するハイブリッドパワーコンディショナ100は、自装置(ハイブリッドパワーコンディショナ100)の入出力AC電力に対するAC指令値を設定し、蓄電池20の充放電を制御するコントローラ140を備える。 - 特許庁
To effectively collect required data without the need of connection of a general-purposed data collection apparatus separately by making use of a controller provided in freezing equipment when data such as operation states of the freezing equipment are collected, and ensure reduction of communication load, and properly deal with failure occurrence.例文帳に追加
冷凍設備の運転状態などのデータを収集する場合、これら冷凍設備に設けられているコントローラおよびこれに接続されている信号通信線を利用して、別途、汎用のデータ収集装置などを接続する必要がなく、効率よく必要なデータだけを収集でき、通信負荷軽減も図ることができ、異常発生に適切に対処できる冷凍設備のデータ収集・転送装置を得る。 - 特許庁
A directional coupler 104 is installed in the output side of the power amplifier 102, increase of reflection wave power from a load is detected by a power detector (detection circuit) 106 through the directional coupler 104, and power voltage supplied to the power amplifier 102 is gradually reduced by supplying the detection signal of the power detector 106 to the power voltage controller 109 of the power detector.例文帳に追加
電力増幅器102の出力側に方向性結合器104を設け、負荷からの反射波電力の増大を方向性結合器104を介して電力検出器(検波器)106で検出し、電力検出器106の検出信号を電力増幅器電源電圧制御回路109に与えることにより、電力増幅器102へ供給する電源電圧を徐々に低下させる。 - 特許庁
In this engine controller for controlling such an engine that hydrogen is directly supplied into a combustion chamber and burned, when torque down control conditions are determined to be established after it is determined whether the torque down control conditions are established or not, for example, a hydrogen injection timing is correctively advanced from a compression stroke to a intake stroke under high rotational speed and high load conditions to lower the drive torque of the engine.例文帳に追加
燃焼室内に水素を直接供給して燃焼させるエンジンを制御するためのエンジン制御装置であって、トルクダウン制御条件が成立したか否かを判定した上で、トルクダウン制御条件が成立したと判定された時に、エンジンの駆動トルクを低下させるべく、例えば、高回転・高負荷の条件下で、水素の噴射タイミングを圧縮行程から吸気行程側に進角補正する。 - 特許庁
In this vehicle controller, an engine ECU 22 inhibits calculation of basic temperature of catalyst Tbase based on engine speed NE and engine load factor KL when an engine 11 is intermittently stopped and retracts each temperature reduction corrected value Tai, Tsp decided in accordance with outside air temperature and vehicle speed from the basic temperature of catalyst Tbase inferred at the previous time to estimate simulated temperature of catalyst, tempcat.例文帳に追加
エンジン11が間欠停止された場合、エンジンECU22は、エンジン回転数NEとエンジン負荷率KLに基づく基本触媒温度Tbaseの算出を禁止して、前回推定した(間欠停止直前の)基本触媒温度Tbaseから外気温と車速に応じて決定される各温度低下補正値Tai,Tspを減算して、触媒模擬温度tempcatを推定する。 - 特許庁
In the control device for the marine internal combustion engine 1 provided with a governor device 10 changing combustion control parameter of the internal combustion engine 1 to control speed of the internal combustion engine 1 to target speed, a controller 11 of the governor device 10 controls change of combustion control parameters due to load fluctuation of the internal combustion engine 1 when the target speed is established in a predetermined speed range.例文帳に追加
内燃機関1の回転数が目標回転数に調整されるように内燃機関の燃焼制御パラメータを変更するガバナ装置10を備えた舶用内燃機関の制御装置において、所定の回転数範囲内に目標回転数が設定されている場合、ガバナ装置10のコントローラ11は、内燃機関1の負荷変動時における燃焼制御パラメータの変更を制限する。 - 特許庁
To provide a motor controller in which operational processing for control is simplified at the time of synchronous control of a plurality of motors having different characteristics or load, degree of lead or lag can be regulated within an allowable range of control, and abrupt speed change control can be avoided even when the operating direction of the motor is reversed.例文帳に追加
特性及び負荷の一方又は双方が異なる複数の電動機の同期制御を行うのに際して、制御のための演算処理を簡略化するとともに、制御の許容範囲内での進みや遅れの程度を調整する制御を可能し、更に電動機の動作方向が反転した際にも急激な速度変更制御が行われるのを回避することを可能とする電動機の制御装置を提供する。 - 特許庁
The motor controller employed in a motor 60 for rotary driving a compressor 50 having periodic load torque variation and controlling drive torque of a motor 60 depending on the characteristics of the compressor 50 comprises a means for estimating mechanical rotation angle θ of the compressor 50, and an impulse force relaxing means for reducing drive torque at rotation angles θA and θB predetermined based on the rotation angle θ.例文帳に追加
周期的な負荷トルク変動を有する圧縮機50を回転駆動するモータ60に用いられ、圧縮機50の特性に応じてモータ60の駆動トルクを制御するモータ制御装置において、圧縮機50の機械的な回転角θを推定する回転角推定手段と、回転角θに基づいて予め定められた所定の回転角θA、θBにおいて駆動トルクを低減する衝撃力緩和手段とを備えている。 - 特許庁
The internal combustion engine provided with the fuel injection device 1 pressurizing and pressure-feeding fuel supplied from a fuel supply pump to a fuel injection valve by the plunger is provided with a biotechnology fuel supply means capable of mixing biotechnology fuel into fuel supplied to the fuel injection device, and a controller 40 controlling the biotechnology fuel supply means to reduce mixing quantity of biotechnology fuel with accompanying rise of engine speed or engine load.例文帳に追加
燃料供給ポンプにより供給された燃料をプランジャにより加圧して燃料噴射弁に圧送する燃料噴射装置を備えた内燃機関(エンジン)において、前記燃料噴射装置に供給される燃料にバイオ燃料を混入せしめるバイオ燃料供給手段と、前記エンジンの回転数(エンジン回転数)またはエンジン負荷の上昇に従い前記バイオ燃料の混入量を減少するように前記バイオ燃料供給手段を制御するコントローラとを備えたことを特徴とする。 - 特許庁
The fuel injection device includes: a fuel injection valve 8 installed in an internal combustion engine; a determiner 44 for determining whether cavitation is insufficient in fuel injected by the fuel injection valve 8; and an injection controller 46 for controlling either one of promoting the production of cavitation or promoting atomization of the fuel injected by the fuel injection valve 8, depending on a load of the internal combustion engine, when the determiner 44 determines cavitation is insufficient.例文帳に追加
内燃機関に設けられた燃料噴射弁8と、燃料噴射弁8が噴射する燃料中のキャビテーションが不足しているか判定する判定手段44と、判定手段44が、キャビテーションが不足していると判定した場合、内燃機関の負荷に応じて、キャビテーションの生成を促進する制御、又は燃料噴射弁8により噴射される燃料の微粒化を促進する制御、のいずれか一方を行う噴射制御手段46と、を具備することを特徴とする燃料噴射装置。 - 特許庁
The current command is made variable depending on the load torque of the motor by adding the output value from the proportional controller to a current command value for minimizing the driving current of the motor.例文帳に追加
前記課題を解決し、停止時、動作時においてもモータの負担に応じて電流指令を可変出来るように制御するマイクロステップ機能を有するステッピングモータの駆動装置において,正弦波状モータ電流を発生させるための励磁角度生成器と,電流制御器と,電流検出器と,角度検出器と,前記電流検出器の電流値および該角度検出器のロータ回転角度値からトルク成分電流を算出する座標変換器と,該トルク成分電流を絶対値に変換する絶対値変換器と,該絶対値変換したトルク成分電流に比例した値を出力する係数1以上の比例制御器を有し,モータを駆動することができる最小電流とする電流指令値に該比例制御器出力値を加算して,モータの負荷トルクに応じて電流指令を可変するように構成する。 - 特許庁
| 例文 |
| Copyright © Japan Patent office. All Rights Reserved. |
|
ログイン |
Weblio会員(無料)になると
|
|
ログイン |
Weblio会員(無料)になると
|