| 例文 |
STEP-SET ALARMの部分一致の例文一覧と使い方
該当件数 : 21件
Next, a package to perform an alarm processing is set in a step F2.例文帳に追加
次にステップF2において、警報処理するパッケージを設定する。 - 特許庁
Whether the alarm conditions set in the step S3 are established is determined in a step S4.例文帳に追加
ステップS4では、ステップS3で設定された警報条件が成立したか否かを判定する。 - 特許庁
When the "alarm function" is set ON, it is judged whether the current point is an alarm timing point (step S202).例文帳に追加
ONとなっている場合には、現時点が警告タイミングであるか否かを判断する(ステップS202)。 - 特許庁
The alarm set time T is a prescribed value set in a step S7 according to the awakening degree (alarm sensitivity) of the driver.例文帳に追加
ここで、警報設定時間Tは、ドライバの覚醒度(警報感度)に応じてステップS7にて設定された所定値である。 - 特許庁
To provide an alarm clock for accurately pointing to an alarm set scale in increments of ten minutes and an alarm set scale in increments of five minutes regardless of a step-moving aiming hand and for setting alarm time rapidly.例文帳に追加
ステップ運針する目安針でありながら10分刻み目覚しセット目盛と5分刻み目覚しセット目盛を、正確に指すことができ、また、迅速に目覚し時刻をセットすることができる目覚し時計を提供することにある。 - 特許庁
Additionally, a lower limit value (second alarm threshold) of the alarm threshold set on the basis of vehicle recommended pressure is set, and the decrease of the tire air pressure is determined even when the reception pressure reaches the lower limit value of the alarm threshold or below (step 210).例文帳に追加
また、車両推奨圧に基づいて設定された警報閾値の下限値(第2警報閾値)を設定し、受信圧がこの警報閾値の下限値以下になってもタイヤ空気圧の低下と判定する210。 - 特許庁
The alarm threshold (first alarm threshold) obtained by lowering pressure by an alarm detection decompression rate from reception pressure determined in the past is set, and the decrease of the tire air pressure is determined when the reception pressure reaches the alarm threshold or below (step 205).例文帳に追加
過去に求められた受信圧から警報検出減圧率分だけ低下させた警報閾値(第1警報閾値)を設定し、受信圧がこの警報閾値以下になるとタイヤ空気圧の低下と判定する205。 - 特許庁
Next, data D10 of alarm information (1) on the information management table 21 set in the step F2 is transferred to a register 3 in a step F3.例文帳に追加
次にステップF3において、ステップF2で設定された情報管理テーブル21の警報情報(1)のデータD10をレジスタ3に転送する。 - 特許庁
When steering by the driver for the prevention of lane deviation is detected by determination in a step S15, only the execution of the tactile alarm is stopped (step S16), but the issuance of alarm sound is continued until the lapse of alarm set time T from the start of issuance of the alarm sound is determined in a step S17.例文帳に追加
ステップS15の判断によってドライバによって車線逸脱防止のための操舵が検出された場合にはタクタイル警報の実行だけが中止される(ステップS16)が、警報音の発報は、警報音の発報が開始されてから警報設定時間Tが経過したことがステップS17にて判断されるまで継続される。 - 特許庁
If automatic setting is selected (step S11, 'YES'), the calculated reproducing time is automatically set as the call time for incoming or the alarm reproducing time for alarm (step S12).例文帳に追加
そして着信時における呼び出し時間、また、アラーム時におけるアラーム再生時間を、自動設定が選択されている場合は(ステップA11,「YES」)計算した再生時間に自動的に設定する(ステップA12)。 - 特許庁
When the selected set pressure detection signal is output from the pressure sensor (YES at step S2), the controller determines that pressure abnormality has occurred in a chemical cabinet (step S4) and makes an alarm output a predetermined alarm sound or alarm indication (step S5).例文帳に追加
選択された設定圧力検出信号が圧力センサから出力されると(ステップS2でYES)、制御装置は薬液キャビネット内に圧力異常が発生したと判定し(ステップS4)、警報器から所定の警報音または警報表示を出力させる(ステップS5)。 - 特許庁
When reaching the alarm time set by a step S21, even if a use form at its time is the manner mode or the silencing mode, when a determining means determines that the alarm function of a cellular phone is used as an alarm clock in a step S22, a forced rumbling means operates and forcibly sounds the alarm sound from a sounder part 13 in a step S23.例文帳に追加
ステップS21で設定したアラーム時刻に達すると、その時の使用形態がマナーモードまたは消音モードであっても、ステップS22で判定手段が携帯電話機のアラーム機能を目覚まし時計として使用していると判断した場合、ステップS23で強制鳴動手段が作動してサウンダ部13からアラーム音を強制的に鳴らす。 - 特許庁
If date and time set in an alarm come (Step S30, Yes), then the remaining battery level of a battery 124 is detected by a remaining battery level detection section 126 (Step S40).例文帳に追加
アラームの設定日時になった場合には(ステップS30のYes)、電池残量検出部126によって電池124の残量が検出される(ステップS40)。 - 特許庁
When set alarm time comes, an alarm sound is made, display image data of "1" are selected from a snooze image data region, and image P1 is displayed in the display section (Step S202).例文帳に追加
アラーム設定時刻となったならばアラーム音を発生させるとともに、スヌーズ画像データ領域から「1」の表示イメージデータを選択し、画像P1を表示部に表示させる(ステップS202)。 - 特許庁
When the measured output level S (m) is reduced, the threshold value is set again and alarm for promoting maintenance is outputted (step ST16).例文帳に追加
測定出力レベルS(m)がより低下した場合には、閾値の再設定と共にメンテナンスを促す警告を出力する(ステップST16)。 - 特許庁
Thus, the aiming hand 6 is moved with a step of 1° or 0.5°, and is rotated by five steps, namely one scale of an alarm set scale in increments of ten minutes, or by 2.5°, namely one scale of an alarm set scale in increments of five minutes.例文帳に追加
これにより、目安針6は1ステップで1°あるいは0.5°運針され、5ステップさせると、10分刻み目覚しセット目盛の1目盛分である5°あるいは5分刻み目覚しセット目盛の1目盛分である2.5°回転する。 - 特許庁
Concretely the output level of the alarm is set to the reference level when the distance between the vehicle concerned and other car is larger than the reference distance (Step S280).例文帳に追加
具体的には、自車と他の車両との間の距離が基準距離より大きいときには、警報の出力レベルを基準レベルに設定する(ステップS280)。 - 特許庁
And, if automatic setup is selected (step A11, "YES"), a calling time upon receiving the call and an alarm reproduction time during alarming are automatically set to the calculated reproduction time (step A12).例文帳に追加
そして着信時における呼び出し時間、また、アラーム時におけるアラーム再生時間を、自動設定が選択されている場合は(ステップA11,「YES」)計算した再生時間に自動的に設定する(ステップA12)。 - 特許庁
If the bag or the attache case containing the cellular telephone is stolen, when the bag, etc., is opened to take out the contents, the optical sensor detects a light and automatically transmits an alarm to an alarm transmission destination telephone number which is previously set (step 104).例文帳に追加
いま、携帯電話機が収納されたバックやカバンが盗難にあった場合、中のものを取り出すために蓋を開けた時点で、光センサは光を検出して、予め設定しておいた警報発信先電話番号に自動的に警報を発信する(ステップ104)。 - 特許庁
Then, the light control circuit 1042 supplies power to the illumination LED unit 100 when the voltage value after step-down is a threshold or more set beforehand, and when the voltage value is lower than the threshold and higher than 0 [V], stops supply of power and switches off the illumination LED unit 100 and makes an alarm LED unit 110 light.例文帳に追加
そして、調光制御回路1042は、降圧後の電圧値が予め設定された閾値以上の場合に、照明用LEDユニット100へ電力供給を行い、電圧値が上記閾値よりも低く、且つ、0[V]よりも高い場合に、照明用LEDユニット100への電力供給を停止して消灯させるとともに、警報用LEDユニット110を点灯させる。 - 特許庁
| 例文 |
| Copyright © Japan Patent office. All Rights Reserved. |
|
ログイン |
Weblio会員(無料)になると
|
|
ログイン |
Weblio会員(無料)になると
|