| 意味 | 例文 |
IGNITION POINTの部分一致の例文一覧と使い方
該当件数 : 212件
When the EGR amount is reduced by deposition of carbon, ignition timing control is continued as it is, and an EGR opening θegr is corrected so that a maximum cylinder internal pressure crank angle θPmax wherein a cylinder internal pressure reaches a maximum value is an optimum crank angle, and thereby, the EGR amount is controlled to be the best fuel consumption point.例文帳に追加
カーボンの堆積などでEGR量が低下したときには、そのままの点火時期制御を継続した上で、筒内圧が最大値に達する最大筒内圧クランク角θPmaxが最適クランク角となるようにEGR開度θegrを補正することにより、EGR量を最良燃費点に制御する。 - 特許庁
Then, the method not only controls a vaporization loss of manganese in the molten steel better than before, while surely keeping the temperature necessary for vacuum decarburizing treatment, but also enables inexpensive and swift vacuum decarburization, because the method controls evaporation of manganese by cooling the ignition point at which the oxygen jet 5 collides with the molten steel, by water.例文帳に追加
酸素ジェット5が溶鋼に衝突する火点を水により冷却してマンガンの蒸発を抑制するので、真空脱炭処理に必要な温度を確保できるとともに、溶鋼中マンガンの蒸発損失を従来より抑制できるばかりでなく、安価で、かつ、迅速な真空脱炭が可能になる。 - 特許庁
This additive for modified asphalt consists of a vacuum distillation residual oil produced from the vacuum distillation process in petroleum refinery operations, having an ignition point of ≥280°C, dynamic viscosity at 60°C of ≥3,000 mm2/s, and dynamic viscosity at 120°C of ≤200 mm2/s.例文帳に追加
石油精製の減圧蒸留工程において得られる減圧蒸留残油であって、引火点が280℃以上であり、温度60℃における動粘度が3000mm^2/sec以上であり、かつ温度120℃における動粘度が200mm^2 /sec以下である改質アスファルト用添加材である。 - 特許庁
As the collar part 1d and the projection 1e closely contact a glass bulb 2, the socket has such a structure that the leaked flammable refrigerant can not get into the area where the spark is generated when the electricity receiving terminal 2b of the lamp and a contact point 1c contact each other, therefore, the spark is prevented from becoming a cause of ignition.例文帳に追加
襟部1d及び突条1eは電球のガラス球2cに密着しているため、電球を取り付ける際、電球受電端子2bと接点1cが接触する瞬間に生じる火花に対して、外部に漏れた可燃性冷媒が接触しない構造になっているので火花が着火源となるのを防ぐことができる。 - 特許庁
The interception projectile 30 includes an explosive charge 32 filled around an axis of a bottomed cylindrical shell 31, a powder-like heat resistant material 33 filled around the explosive charge 32 in the shell 31 and having a melting point higher than a temperature of heat generated by ignition to the explosive charge 32, and an electronic type fuse 34 igniting the explosive charge 32.例文帳に追加
迎撃弾30は、有底の円筒形状である弾殻31の軸の周りに充填された炸薬32と、弾殻31内における炸薬32の周りに充填されており、炸薬32への点火によって生ずる熱の温度よりも高い融点を有する紛状耐熱材33と、炸薬32に点火する電子式信管34とを備えている。 - 特許庁
To provide a display system for a vehicle and a motor control device, used for this system, which reduces the occurrence of momentary dislocation in a display position of an image, even when at least any one of a display position adjusting switch and a vehicle ignition switch is operated for OFF in the middle of moving a rotor to the next excitation stable point.例文帳に追加
回転子が次の励磁安定点へ移動する途中に表示位置調整用スイッチ及び車両のイグニッションスイッチの少なくともいずれか一方がオフ操作された場合であれ、画像の表示位置に一瞬のずれが生じることを低減することのできる車両用表示システム及びこのシステムに用いられるモータ制御装置を提供する。 - 特許庁
When the temperature in the heating furnace reaches the temperature T1 higher than the preset target temperature T0, the heating of the heating furnace is stopped, and when the temperature in the heating furnace reaches the preset temperature T2 which is higher than the temperature T1 and lower than the ignition point of the alloy after the heating is stopped, the inert gas is injected in the heating furnace.例文帳に追加
加熱炉内の温度が予め設定した目標温度T0より高い温度T1となると加熱炉の加熱を停止させ、加熱を停止させた後に加熱炉内の温度が前記温度T1より高くかつ前記合金の発火温度より低い予め設定した温度T2となると、加熱炉内に不活性ガスを噴射する。 - 特許庁
To provide an explosion proof type solenoid valve arranged in an explosion proof region such as a discharge port of a tank storing, for example, oil, explosive liquid such as chemicals and liquefied gas, and inflammable gas and capable of suppressing heat generation from a heat generation source such as a solenoid part driving a plunger valve element below ignition point of inflammable gas to provide explosion proofing property effectively.例文帳に追加
本発明は防爆型のソレノイドバルブに関し、例えば石油、化学薬品等の爆発性の液体や液化ガス、可燃性ガス等を貯蔵するタンクの排気口等の防爆領域に設置され、プランジャ弁体を駆動させるソレノイド部等の熱発生源からの発熱を可燃性ガス等の発火点以下に抑えて有効に防爆性を発揮させる。 - 特許庁
To make adjusting an engine output easy when a traction control starts, in an engine which circulates more exhaust gas than a predetermined amount and jets fuel into a cylinder at an earlier point than at the top dead center in a compression stroke so that premixed compression ignition combustion starts close to the top dead center where the ratio of premixed combustion is bigger than that of diffusion combustion.例文帳に追加
予混合燃焼の割合が拡散燃焼の割合よりも多い予混合圧縮着火燃焼がTDC付近から開始するように、圧縮行程上死点よりも前の早い時期に燃料を筒内に噴射するとともに設定量以上の排気を還流させるようにしたエンジンの燃焼制御装置において、トラクション制御が開始されたときのエンジン出力の調節を容易にする。 - 特許庁
To provide a polymerizable acrylophosphonic acid having perfect hydrolysis stability in the presence of water at room temperature, suitable for the preparation of polymers, adhesives or other materials (mainly materials for dental use) or a component for the preparation and usable as a comonomer to give an organic polymer having important characteristics in polymer chemistry comprising high thermal stability, ignition point, adhesivity and solubility in polar solvent.例文帳に追加
室温、水の存在下で、特に完全に加水分解安定性で、ポリマー、接着剤または他の材料(主に歯科用材料)の調製用または成分として適した、重合可能なアクリルホスホン酸であって、主にコモノマーとしてポリマー化学で重要な高い熱安定性と着火温度、良好な接着特性と極性溶媒への溶解性を有する有機ポリマーを調製できるアクリロホスホン酸を提供する。 - 特許庁
MEANS FOR AUTOMATICALLY EFFICIENTLY AND CLEANLY UTILIZING ENERGY OF FOSSIL FUEL IN ENGINE FOR AUTOMOBILE AND OTHERS ADJUSTING TEMPERATURE OF FUEL AND AIR AT NEAR IGNITION POINT TO SUPPLY ENGINE FOR例文帳に追加
自動車をはじめ多くの分野で使われているエンジンは殆どが化石燃料をエネルギーとしている。そのエネルギーをいかに効率よくクリヤーに引き出すかが大きな課題となっており、その手段として燃料・空気の混合比率を自動制御したり高価な触媒を使ったりしているが、燃料・空気の温度自動制御は出来ていない。そこで燃料・空気を発火点に近い温度にヒーター又は排気熱を利用して自動制御とし温度調節を計りエンジンに供給するものとする。 - 特許庁
The internal-combustion engine including at least one cylinder in which a mixture gas of fuel and air in the cylinder is compressed by a piston, wherein the temperature of the mixture gas in the combustion chamber is raised to 80-98 % of the natural firing point of the mixture gas, and the combustion ignition is controlled on the time basis by incidence of a laser beam into the combustion chamber.例文帳に追加
シリンダ内の燃料・空気−混合気がピストンによって圧縮される少なくとも1本のシリンダを有した内燃機関において、燃焼室内の燃料・空気−混合気の温度が燃料・空気−混合気の自然着火温度の少なくともおよそ80%以上から最高にておよそ98%までに引き上げられ、燃焼点火は燃焼室内へのレーザ光の入射によって時間的に制御されて行われる内燃機関。 - 特許庁
| 意味 | 例文 |
| Copyright © Japan Patent office. All Rights Reserved. |
|
ログイン |
Weblio会員(無料)になると
|
|
ログイン |
Weblio会員(無料)になると
|