小窓モード


プレミアム

ログイン
設定

設定

Weblio 辞書 > 英和辞典・和英辞典 > 和英マシニング用語 > tolerance factorの意味・解説 

tolerance factorとは 意味・読み方・使い方

発音を聞く
プレーヤー再生
ピン留め

追加できません

(登録数上限)

単語を追加

意味・対訳 許容因子

和英マシニング用語集での「tolerance factor」の意味

tolerance factor


「tolerance factor」の部分一致の例文検索結果

該当件数 : 15



例文

To allow the setting of transmitting condition that a probe surface temperature rise becomes a tolerance or less while realizing an SNR (signal/noize ratio) improvement factor set by a user.例文帳に追加

ユーザーによって設定されたSNR改善度を実現しつつ、かつプローブ表面温度上昇が許容値以下となるように送信条件を設定できるようにする。 - 特許庁

The new plant exhibiting properties such as low-sulfur environmental tolerance is created by transferring the original plant with a gene encoding transcription factor SLIM1/EIL3 that controls the sulfur assimilation system and the sulfur secondary metabolism system.例文帳に追加

硫黄同化系および硫黄二次代謝系を制御する転写因子SLIM1/EIL3をコードする遺伝子を植物に導入し、低硫黄環境耐性などの性質を示す植物を作出する。 - 特許庁

To provide a regulator circuit which makes it possible to use a small- sized transistor with a high current amplification factor by improving the breakdown tolerance of a transistor against a surge voltage and an impulse voltage.例文帳に追加

サージ電圧やインパルス電圧に対するトランジスタのブレークダウン耐力を向上させ、電流増幅率が高くて小型のトランジスタを使用可能にしたレギュレータ回路を提供する。 - 特許庁

To provide a crimping failure determination data adjustment method of a terminal crimping failure detection device capable of facilitating treatment by identifying an area used as a factor of determination of a crimping failure and an allowable tolerance used as a determination condition and by automatically changing only the allowable tolerance.例文帳に追加

圧着不良の判定の要因となったエリアおよび判定条件となった許容公差を特定し、その許容公差のみを自動的に変更することによって対処の容易化を図った端子圧着不良検出装置の圧着不良判定データ調整方法を提供する。 - 特許庁

To provide an amplification factor initial setting method of a blurring signal, an imaging device which can easily perform setting for performing appropriate blurring correction even when sensitivity of a blurring detection sensor exceeds a tolerance.例文帳に追加

ぶれ検出センサーの感度が許容値を超えていても適切なぶれ補正を行えるようにする設定を容易に行えるぶれ検出信号の増幅率初期設定方法、撮像装置を提供する。 - 特許庁

To provide a defective dimension estimating method an a device therefor in which the setting standard of safety factor is made clear when the maximum defective dimension is estimated, and structural designing and strength evaluation in consideration of desired tolerance are performed.例文帳に追加

最大欠陥寸法を推定する際の安全率の設定基準を明確とし、所望の裕度を考慮した構造設計や強度評価が可能となる欠陥寸法推定方法及び装置を提供する。 - 特許庁

例文

In such a configuration, the piezoelectric element 11, the wiring connected to the electrodes and a connecting part thereof can be shielded from an environmental factor such as moisture, thereby improving environmental tolerance of the ultrasonic sensor 10.例文帳に追加

この構成によれば、圧電素子11と各電極に接続される配線及びその接続部とを、水分など環境因子から遮断することができるので、超音波センサ10の耐環境性を向上させることができる。 - 特許庁

>>例文の一覧を見る

調べた例文を記録して、 効率よく覚えましょう
Weblio会員登録無料で登録できます!
  • 履歴機能
    履歴機能
    過去に調べた
    単語を確認!
  • 語彙力診断
    語彙力診断
    診断回数が
    増える!
  • マイ単語帳
    マイ単語帳
    便利な
    学習機能付き!
  • マイ例文帳
    マイ例文帳
    文章で
    単語を理解!
  • その他にも便利な機能が満載!
Weblio会員登録(無料)はこちらから

JST科学技術用語日英対訳辞書での「tolerance factor」の意味

tolerance factor


日英・英日専門用語辞書での「tolerance factor」の意味

tolerance factor


Weblio例文辞書での「tolerance factor」に類似した例文

tolerance factor

例文

a modulus

例文

a hydrometer

例文

the retention rate

Weblio例文辞書はプログラムで機械的に意味や英語表現を生成しているため、不適切な項目が含まれていることもあります。ご了承くださいませ。

「tolerance factor」の部分一致の例文検索結果

該当件数 : 15



例文

To provide a method capable of optimizing a plant control constant in consideration of a variable factor, and determining a domain wherein a plurality of response characteristics on a plurality of control constants are within a plant operation tolerance.例文帳に追加

変動要因を考慮したプラント制御定数の最適化が実施可能であり、かつ複数の制御定数について複数の応答特性がプラント運転許容範囲内にある領域の判断が行える方法を提供すること。 - 特許庁

When the outside diameter of the wire (w) is different by its tolerance or more from a normal one, it is determined that there is a defective factor such as a depression and a crack on its surface, and the looseness of a core resulting in the breakage of the core or a contact failure has occurred inside the sheath.例文帳に追加

電線wの外径が正規のものから公差以上に離れたものは表面に窪みや亀裂等の不良因子があると判定し、外皮の内部で芯線切れや接触不良に繋がる芯線のばらけが生じているとみなす。 - 特許庁

To accurately detect the quantity of developer as needed, irrespective of the manufacturing variation of a planar antenna itself, the manufacturing variation of a cartridge caused by the positional deviation of the planar antenna in a developer container and the variation of the device body factor, including the tolerance of an applied bias.例文帳に追加

平面アンテナ自体の製造ばらつき、現像剤収納容器内での平面アンテナの位置ずれによるカートリッジを製造する上で生じるばらつき、及び印加バイアスの公差を含む装置本体要因のばらつきがあっても、随時現像剤量を正確に検知する。 - 特許庁

Even when the amplification factor of the amplifying part 10 is set appropriately so as to cause the comparison part to control the opening/ closing of the external triac Q in dim outside lighting conditions, a disturbance light tolerance L is kept at or higher than a prescribed quantity by the selection part 10, and malfunctions due to fluctuations in external light and due to disturbance light can be prevented.例文帳に追加

外光が暗いときに比較部に外部のトライアックQを開閉制御させるように変換増幅部10の増幅率を適宜設定してときにも、切換部10により外乱光耐量Lを所定量以上に保って、外光のゆらぎ及び外乱光に対する誤動作を防止することができる。 - 特許庁

The error level of the treatment order is calculated based on the attribute category to be considered for each treatment facility pre-stored in a connection evaluation table, a tolerance of the attribute difference of the connecting part, which is quantified step by step of each attribute category, and a weighting factor preset for each treatment facility.例文帳に追加

処理順エラーレベルは、接続評価テーブルに予め格納された処理設備毎に考慮すべき属性種類、及びこの属性種類毎に段階的に定量化された接続部の属性差の許容範囲、並びに処理設備毎に予め設定された重み付け係数に基づいて算出される。 - 特許庁

The invention relates to the plant with a high tolerance to cadmium transformed with a polynucleotide selected from (I) a polynucleotide having a base sequence described in Sequence No 1 and (II) a polynucleotide which hybridizes in a stringent condition with a polynucleotide having a specific base sequence originated from yeasts, and encoding a protein having an activity of yeast cadmium factor 1 (YCF1).例文帳に追加

(I) 配列番号1に記載の塩基配列を有するポリヌクレオチド、並びに、(II) 酵母由来の特定な塩基配列を有するポリヌクレオチドとストリンジェントな条件下でハイブリダイズするポリヌクレオチドであって、酵母カドミウムファクター1(YCF1)活性を有するタンパク質をコードするポリヌクレオチド、から選択される少なくとも1種のポリヌクレオチドで形質転換された、カドミウム耐性植物。 - 特許庁

To provide a sample tube for a nuclear magnetic resonance apparatus with a detection coil for generating a high frequency magnetic field and a useful method for manufacturing the sample tube, in which a dimensional tolerance of an inner diameter of the sample tube can be reduced, a filling factor can be increased, and a volume susceptibility can be made comparable to the volume susceptibility of a sample to be analyzed if necessary.例文帳に追加

試料管の内径の寸法公差を小さく、またフィリングファクターを高くすることができ、必要によって、体積磁化率を分析対象試料の体積磁化率と同程度とすることができるような、高周波磁場を発生するための検出コイルを備えた核磁気共鳴装置用試料管、およびそのような試料管を製造するための有用な方法を提供する。 - 特許庁

例文

To provide a medicinal composition for treating and/or preventing hyperglycemia, impaired glucose tolerance (IGT), diabetes-related disease or diabetes complication caused by type-1 diabetes, type-2 diabetes, gestational diabetes or another factor, containing a compound having a new structure, exhibiting low side effects and having excellent human SGLT1- and/or SGLT2-inhibiting activities, or a hydrate thereof as an active ingredient.例文帳に追加

新規な構造を有し、副作用が低く優れたヒトSGLT1および/またはSGLT2阻害活性を有する化合物またはその水和物を有効成分として含有する、1型糖尿病、2型糖尿病、妊娠糖尿病、その他の要因による高血糖症、耐糖能不全(impaired glucose tolerance:IGT)、糖尿病関連疾患または糖尿病合併症を治療および/または予防するための医薬組成物を提供すること。 - 特許庁

>>例文の一覧を見る


tolerance factorのページの著作権
英和・和英辞典 情報提供元は 参加元一覧 にて確認できます。

   
住友電工ハードメタル住友電工ハードメタル
Copyright(c) Sumitomo Electric Hardmetal Corp. All rights reserved.
独立行政法人科学技術振興機構独立行政法人科学技術振興機構
All Rights Reserved, Copyright © Japan Science and Technology Agency
日中韓辭典研究所日中韓辭典研究所
Copyright © 2026 CJKI. All Rights Reserved

ピン留めアイコンをクリックすると単語とその意味を画面の右側に残しておくことができます。

こんにちは ゲスト さん

ログイン

Weblio会員(無料)になると

会員登録のメリット検索履歴を保存できる!

会員登録のメリット語彙力診断の実施回数増加!

無料会員に登録する

このモジュールを今後表示しない
みんなの検索ランキング
閲覧履歴
無料会員登録をすると、
単語の閲覧履歴を
確認できます。
無料会員に登録する
英→日 日→英
こんにちは ゲスト さん

ログイン

Weblio会員(無料)になると

会員登録のメリット検索履歴を保存できる!

会員登録のメリット語彙力診断の実施回数増加!

無料会員に登録する

©2026 GRAS Group, Inc.RSS