i vs.とは 意味・読み方・使い方

In an (i-1)th scanning line, the impression voltage Vs and the impression period Ta of a horizontal-direction signal line are made to be the same as those in the i-th scanning line which is not to be thinned with respect to the (i+1)th scanning line which is to be thinned.例文帳に追加

間引くｉ＋１番目の走査線に対し、ｉ−１番目の走査線では、水平方向信号線の印加電圧Ｖ_s と印加期間Ｔ_a を、間引かないｉ番目の走査線と同じにする。 - 特許庁

Then, a prediction current value I flowing in the switch when the switch is parallel-turned is calculated based on the voltage difference Vs and the network impedance.例文帳に追加

そして、電圧差Ｖｓと回路網インピーダンスを基に、切替開閉器を並列投入した場合に切替開閉器に流れる予測電流値Ｉを算出する。 - 特許庁

The pulse current value operation part 24 of the LED lighting circuit 20 refers to the drive current value vs. emission color property of the LED element 22 and converts the color signal c that instructs the desired emission color into a peak value signal i.例文帳に追加

ＬＥＤ点灯回路２０のパルス電流値演算部２４は、ＬＥＤ素子２２の駆動電流値対発光色特性を参照して、所望発光色を指示する色信号ｃを波高値信号ｉに変換する。 - 特許庁

An input terminal Y for each memory element is connected with a ϕI line 110 via resistances R_a, R_b, R_c, R_d, and a power source terminal VS is connected with a VGA line 113.例文帳に追加

さらに、各メモリ素子の入力端子Ｙは抵抗Ｒ_a ，Ｒ_b ，Ｒ_c ，Ｒ_d を介してφ__I ライン１１０に、電源端子Ｖ_S はＶ_GAライン１１３に接続されている。 - 特許庁

The operating current I during the normal operation of the light emitting element is set in a range of I1 and I2, and the reference voltage Vs for determining the paper sheet to the output voltage V of the light receiving element is set in a range of V1 and V2.例文帳に追加

そして、発光素子の通常動作時の動作電流ＩをＩ１，Ｉ２の範囲内に設定し、かつ受光素子の出力電圧Ｖに対する用紙判定用の基準電圧ＶｓをＶ１，Ｖ２の範囲内に設定する。 - 特許庁

The regression analysis unit 13 performs multiple regression analysis on the measurement data, thereby calculating set points k1(i) and k2(i) that are correlation coefficients between a voltage drop from an own end voltage Vs to a compensation point voltage V(i) and own end passage active power P as well as own end passage reactive power Q.例文帳に追加

回帰分析部１５は、計測データに重回帰分析を行うことにより、自端電圧Ｖｓから補償点電圧Ｖ（ｉ）までの電圧降下と、自端通過有効電力Ｐ及び自端通過無効電力Ｑとの相関係数たる整定値ｋ１（ｉ），ｋ２（ｉ）を算出する。 - 特許庁

Each of output current B101 to B103 of each of the temperature sensors 111 to 113 is converted into voltage y1, y3, y5 by an I/V converter 130, these are coupled together by a coupling circuit 140 and voltage VS to which polygonal line approximation is performed and which changes like a cubic function is generated.例文帳に追加

各温度センサ１１１〜１１３の各出力電流Ｂ１０１〜Ｂ１０３は、Ｉ／Ｖ変換器１３０で電圧ｙ１、ｙ３、ｙ５に変換され、これらが結合回路１４０で結合されて、折れ線近似された３次関数的に変化する電圧ＶＳが生成される。 - 特許庁

Since V=Vx-Vs=(Rx-Rs)(k×i) is satisfied, the voltage difference V corresponds to the resistance difference ΔR (=Rx-Rs), between the reference liquid S and the sample liquid X, where Rs is the resistance value between electrodes s2, s3, Rx is the resistance value between electrodes x2, x3; and k is a coefficient.例文帳に追加

電極ｓ２，ｓ３間の抵抗値をＲｓ、電極ｘ２，ｘ３間の抵抗値をＲｘ、係数をｋとすると、Ｖ＝Ｖｘ−Ｖｓ＝（Ｒｘ−Ｒｓ）（ｋ・ｉ）であるから、電圧差Ｖは基準液Ｓと試料液Ｘとの抵抗差ΔＲ（＝Ｒｘ−Ｒｓ）に対応する。 - 特許庁