小窓モード


プレミアム

ログイン
設定

設定

Weblio 辞書 > 英和辞典・和英辞典 > Weblio例文辞書 > maximum pressure deviationの意味・解説 

maximum pressure deviationとは 意味・読み方・使い方

ピン留め

追加できません

(登録数上限)

単語を追加

Weblio例文辞書での「maximum pressure deviation」に類似した例文

maximum pressure deviation

7

圧力高くする

8

圧力強いこと

10

圧力高くなる

例文

to compress something

15

圧力耐え

例文

to yield to the pressure

例文

to yield to the pressure

例文

decrease the pressure of

例文

mHg of pressure

例文

(a) high voltage

例文

the pressure exerted on something

例文

lift the pressure

Weblio例文辞書はプログラムで機械的に意味や英語表現を生成しているため、不適切な項目が含まれていることもあります。ご了承くださいませ。

「maximum pressure deviation」の部分一致の例文検索結果

該当件数 : 13



例文

When the maximum blood pressure value is received from the CPU 50, the CPU 80 computes the pressure deviation between the maximum pressure value measured by the sphygmomanometer and the maximum pressure value measured by the accuracy confirmation device 60, and if the computed pressure deviation is not more than a threshold, the CPU 80 determines that the accuracy of measurement by the sphygmomanometer satisfies a prescribed standard and is normal.例文帳に追加

CPU50から最高血圧値の受信が得られると、CPU80は、血圧計での最高血圧値と精度確認装置60での最高圧力値との圧力偏差を演算し、その演算した圧力偏差が所定の閾値以下である場合には、血圧計の測定精度が所定の水準を満たし、正常であると判定する。 - 特許庁

A correction value CAFB is computed so that the deviation ΔDP between the maximum cylinder internal pressure change rate DPMAX and the target maximum change rate DPMAXCMD is zero.例文帳に追加

最大筒内圧変化率DPMAXと、目標最大変化率DPMAXCMDの偏差ΔDPが「0」となるように補正値CAFBが算出される。 - 特許庁

Next, the ECU so corrects the opening periods of the gas injection valves 36 of the cylinders 23 that the "combustion pressure deviation" of each maximum combustion pressure from the averaged value comes within the target deviation in all cylinders 23.例文帳に追加

次に、総てのシリンダ23に関して、各最高燃焼圧力の平均値に対する「燃焼圧力偏差」が目標偏差以内に入るように、各シリンダ23のガス噴射弁36の開弁期間を補正する。 - 特許庁

A maximum cylinder internal pressure change rate DPMAX is calculated on the basis of detected cylinder internal pressure PCYL, and a main injection timing map value CAIMM is corrected so that a deviation between the maximum cylinder internal pressure change rate DPMAX and a target maximum change rate DPMAXCMD set in response to an engine operation state, becomes " 0 ".例文帳に追加

検出される筒内圧PCYLに基づいて最大筒内圧変化率DPMAXが算出され、最大筒内圧変化率DPMAXと、機関運転状態に応じて設定される目標最大変化率DPMAXCMDとの偏差が「0」となるように主噴射時期マップ値CAIMMが補正される。 - 特許庁

While calculating the correction quantity of target fuel pressure in a common rail on the basis of the maximum value of the injection rate, the correction quantity of the command timing is calculated on the basis of the deviation quantity (S20).例文帳に追加

噴射率の最大値に基づき、コモンレール内の目標燃圧の補正量を算出するとともに、ずれ量に基づき指令タイミングの補正量を算出する(S20)。 - 特許庁

When an engine operated condition is in a cetane number diagnosis region, the abnormality determination of the cetane number is performed in accordance with the maximum fluctuation crank angle CADPMAX where a pressure change rate dp/dθ of cylinder pressure is the maximum and a crank angle deviation DCA from its target value CADPMB (S12-S16).例文帳に追加

機関運転状態がセタン価診断領域にあるとき、筒内圧の圧力変化率dp/dθが最大となる最大変動クランク角度CADPMAXと、その目標値CADPMBとのクランク角偏差DCAに基づいて、セタン価の異常判定を行う(S12〜S16)。 - 特許庁

例文

Phase discrepancy between a high-pressure fuel pump reference phase position Dang designed to determine high-pressure fuel pump drive timing, and an internal combustion engine rotation phase being an actual reference position is detected as deviation (dVTG) between a VVT maximum lag angle design value VTG and a VVT maximum lag angle learned value Avtg (S156).例文帳に追加

高圧燃料ポンプ駆動タイミングの設計上の高圧燃料ポンプ基準位相位置Dangと実際の基準位置となる内燃機関回転位相との間の位相乖離を、VVT最遅角設計値VTGとVVT最遅角学習値Avtgとの差(dVTG)として検出する(S156)。 - 特許庁

>>例文の一覧を見る

調べた例文を記録して、 効率よく覚えましょう
Weblio会員登録無料で登録できます!
  • 履歴機能
    履歴機能
    過去に調べた
    単語を確認!
  • 語彙力診断
    語彙力診断
    診断回数が
    増える!
  • マイ単語帳
    マイ単語帳
    便利な
    学習機能付き!
  • マイ例文帳
    マイ例文帳
    文章で
    単語を理解!
  • その他にも便利な機能が満載!
Weblio会員登録(無料)はこちらから

「maximum pressure deviation」の部分一致の例文検索結果

該当件数 : 13



例文

Since the phase discrepancy is directly revealed, the high pressure fuel pump reference phase position Dang is corrected by the VVT maximum lag angle deviation dVTG (S158, S160) to eliminate the phase discrepancy.例文帳に追加

直接的に位相乖離が判明するので、このVVT最遅角偏差dVTGで高圧燃料ポンプ基準位相位置Dangを補正して(S158,S160)、位相乖離を解消できる。 - 特許庁

Pressurizing/depressurizing a cuff (pressurizing belt) is repeated two or more cycles, preferably three cycles, each average value and measured value of the highest blood pressure (systolic blood pressure), the lowest blood pressure (diastolic blood pressure) which are measured for every cycle and pulse rate per minute, and the vertical maximum deviation between the measured value and the average value are automatically calculated and displayed.例文帳に追加

カフ(加圧帯)の加圧減圧を2サイクル以上好ましくは3サイクル自動的に繰返し、各サイクル毎に計測した最高血圧(収縮期血圧)、最低血圧(拡張期血圧)及び脈搏数/分の各平均値および計測値と平均値との上下最大偏差値を、最終サイクル終了時に自動的に計算して表示する。 - 特許庁

Using the acquired distance and parameter, the time average value of pressure in the drain pipe and standard deviation are predicted from a predetermined empirical expression, and using the predicted result, the time maximum value and time minimum value of pressure in the drain pipe are predicted from a predetermined empirical expression.例文帳に追加

取得した距離及びパラメータを用いて、予め与えられた実験式から、排水管内圧力の時間平均値、及び標準偏差を予測し、予測結果を用いて、予め与えられた実験式から、排水管内圧力の時間最大値及び時間最小値を予測する。 - 特許庁

Control rotation speed to offset deviation of detected pressure from target pressure established from the control device 13 beforehand in a range between lower limit rotation speed and maximum rotation speed is determined, the opening and closing valve 7 is opened when control rotation speed is higher than the lower limit rotation speed and is closed when control rotation speed is lower than the lower limit rotation speed.例文帳に追加

モータ2の回転数が下限回転数以上最高回転数以下の範囲で、制御装置13から予め設定した目標圧力に対する検出圧力の偏差を打ち消すための制御回転数を決定するとともに、開閉弁7を、制御回転数が下限回転数より大の場合は開弁し、下限回転数未満の場合は閉弁する。 - 特許庁

To discharge ink drops straight from an ink discharge hole by preventing a diaphragm from inclining when the diaphragm of a channel member is formed by cutting by a dicing saw or the like, and eliminating a positional deviation between the ink discharge hole and a maximum pressure generation region (central part of a channel).例文帳に追加

ダイシングソー等の研削加工にて流路部材の隔壁を形成する際に発生する隔壁の傾きを防止し、インク吐出孔と最大圧力発生領域(流路の中央部)との位置ずれをなくし、インク滴がインク吐出孔より真っ直ぐに吐出されるようにする。 - 特許庁

例文

To provide a color image forming device capable of preventing the increase of maximum nip pressure at a nip part by the contact of an intermediate transfer body drum with a photoreceptor or the like and preventing the occurrence of a deviation between the intermediate transfer cylindrical member of the intermediate transfer body drum and the inside member thereof even when both of them are not stuck with an adhesive.例文帳に追加

中間転写体ドラムと感光体等との接触によるニップ部での最大ニップ圧の増大を防ぐことができると共に、中間転写体ドラムの中間転写円筒部材とその内側の部材とを接着剤により接着しなくともこの両者間のズレの発生を防止することができるカラー画像形成装置を提供する。 - 特許庁

>>例文の一覧を見る

maximum pressure deviationのページの著作権
英和・和英辞典 情報提供元は 参加元一覧 にて確認できます。

   

ピン留めアイコンをクリックすると単語とその意味を画面の右側に残しておくことができます。

こんにちは ゲスト さん

ログイン

Weblio会員(無料)になると

会員登録のメリット検索履歴を保存できる!

会員登録のメリット語彙力診断の実施回数増加!

無料会員に登録する

このモジュールを今後表示しない
みんなの検索ランキング
閲覧履歴
無料会員登録をすると、
単語の閲覧履歴を
確認できます。
無料会員に登録する
英→日 日→英
こんにちは ゲスト さん

ログイン

Weblio会員(無料)になると

会員登録のメリット検索履歴を保存できる!

会員登録のメリット語彙力診断の実施回数増加!

無料会員に登録する

©2026 GRAS Group, Inc.RSS